00195941-03-UM SiplaceCA-EN.pdf - 第381页
User Manual SIPLACE CA 6 Component and Die Handling Edition 08/2011 EN 6.1 X Feeder Modules for the Component Trolley from the SIPLACE X Series 381 6 Fig. 6.1 - 2 8 mm X tape feeder module - back view (1) Entry to the ta…
6 Component and Die Handling User Manual SIPLACE CA
6.1 X Feeder Modules for the Component Trolley from the SIPLACE X Series Edition 08/2011 EN
380
6.1.1.5 Design of SIPLACE X Series Tape Feeders
The two following diagrams show the design of the tape feeder module for the X-series with ref-
erence to the 8 mm X tape feeder module.
6
Fig. 6.1 - 1 8 mm X tape feeder module - front view
(1) Locking roller (the locking latch of the component table locks the feeder module in its end po-
sition with the locking roller.)
(2) EDIF (energy and data interface)
(3) Front centering pin
(4) Lever for raising the pickup window in order to thread in and remove the component tape
(5) Pickup window
(6) Outlet of the tape guide channel
(7) Setting the cover foil tension
(8) Cover foil rocker
(9) Cover foil packing wheels
(10)The back centering pin
(11) Type plate
User Manual SIPLACE CA 6 Component and Die Handling
Edition 08/2011 EN 6.1 X Feeder Modules for the Component Trolley from the SIPLACE X Series
381
6
Fig. 6.1 - 2 8 mm X tape feeder module - back view
(1) Entry to the tape guide channel with tape spring
(2) Flap to cover foil container
(3) Integrated blade for cutting off the cover foil
(4) Removal handle, engaged
(5) Operating panel
(6) Drive motor for cover foil packing device
(7) Drive motors for tape transport
(8) Rotary valve for removing components
(9) Front slider guide
(10)Back slider guide
(11) Graphical representation of the pickup position in relation to the component size
6 Component and Die Handling User Manual SIPLACE CA
6.1 X Feeder Modules for the Component Trolley from the SIPLACE X Series Edition 08/2011 EN
382
6
Fig. 6.1 - 3 8 mm X feeder module - tape support and splice sensor
(1) Tape support, removable
(2) Mounting location for the splice sensor
The 8 mm X feeder is equipped with a tape support (item 1 in fig. 6.1 - 3
). It can easily be removed
if necessary.
Insert the tang of a watchmaker's screwdriver into the oval opening in the tape support and
pull the tape support out against the direction of travel of the tape.
When you insert the tape support, make sure that it engages in its desired position.
NOTE 6
Insert the tape support (item 1 in fig. 6.1 - 3
) into the 8 mm X feeder for all 0402 components and
smaller. This will give you a constant Z pick up height and will minimize the time needed to cor-
rect the pick up heights.
Splice sensors can be retrofitted to the X tape feeder modules. There are two versions of the sen-
sor:
Splice sensor for 8 mm and 12 mm X tape feeder modules
Splice sensor for 16 mm to 88 mm X tape feeder modules 6
The splice sensor is installed at the point marked as item 2 in fig. 6.1 - 3
.