00195941-03-UM SiplaceCA-EN.pdf - 第409页
User Manual SIPLACE CA 6 Component and Die Handling Edition 08/2011 EN 6.2 Component Trolley, SIPLACE X-Series 409 6.2.6 Mount for Additional T ape Reel (X-Series) 6 Fig. 6.2 - 8 Mount for additional T ape Reel (X-Series…
6 Component and Die Handling User Manual SIPLACE CA
6.2 Component Trolley, SIPLACE X-Series Edition 08/2011 EN
408
6
Fig. 6.2 - 7 Component table, SIPLACE X-series, front view
(1) Locking latches
(2) Centering pin on the component table
(3) Compressed air coupling
(4) Grounding pin
(5) Centering hole on the component table
User Manual SIPLACE CA 6 Component and Die Handling
Edition 08/2011 EN 6.2 Component Trolley, SIPLACE X-Series
409
6.2.6 Mount for Additional Tape Reel (X-Series)
6
Fig. 6.2 - 8 Mount for additional Tape Reel (X-Series)
(1) Mount for additional tape reel [00141217-xx]
(2) Mounting device for the support
X-series feeder modules can process component tapes without problems if the lateral offset be-
tween the feeder module and the tape reel does not exceed 60 mm. If a predefined setup means
that the maximum permitted offset cannot be maintained, we recommend that you use the mount
for an additional tape reel (item 1). Simply insert the mount into the holder (item 2) and push it until
the offset is less than the maximum permitted value of 60 mm. The component trolley has 5 hold-
ers in total. Each tape reel mount can hold 2 tape reels, which means that up to ten 15" (381 mm)
reels can be positioned above the tape container.
Max. 60 mm
6 Component and Die Handling User Manual SIPLACE CA
6.2 Component Trolley, SIPLACE X-Series Edition 08/2011 EN
410
6.2.7 Tape Container, SIPLACE X Series
6.2.7.1 Description
The tape container can hold reels up to 19" (483 mm) in diameter. The use of partition plates is
described in section 5.4.5 page 348.
6
Fig. 6.2 - 9 Component trolley, SIPLACE X-series, with tape container
(1) Component trolley
(2) Position of the spindles
(3) Waste bin for unused tape
(4) Tape container
(5) Partition plate
(6) Spindle (enlarged)