00195941-03-UM SiplaceCA-EN.pdf - 第433页
User Manual SIPLACE CA 7 Station Enlargements Edition 08/2011 EN 7.1 Nozzle Changer 433 7 Fig. 7.1 - 7 Magazine and nozzle holders (1) Fiducial for determining the position (2) Locking plate in position "magazine o …
7 Station Enlargements User Manual SIPLACE CA
7.1 Nozzle Changer Edition 08/2011 EN
432
Placing a Nozzle Down 7
– The locking plate (item 2 in fig. 7.1 - 7) opens and releases the nozzles.
– The Z-axis of the Collect&Place CA head moves downwards and places the nozzle down.
– The locking plate closes.
– The Z-axis of the Collect&Place CA head moves upwards.
Rejecting Defective Nozzles 7
– At the reject unit (item 4 in fig. 7.1 - 4) the Z-axis of the Collect&Place CA head moves down-
wards and transfers the defective nozzle to the reject unit. The nozzle is turned and does not
fit through the opening any longer.
– The Z axis moves up again and the nozzle is stripped from the sleeve opening.
– The nozzle drops into the reject bin.
User Manual SIPLACE CA 7 Station Enlargements
Edition 08/2011 EN 7.1 Nozzle Changer
433
7
Fig. 7.1 - 7 Magazine and nozzle holders
(1) Fiducial for determining the position
(2) Locking plate in position "magazine open"
(3) Nozzle garage
(4) Fiducial for determining the angular position
(5) Hole for cylinder pin to center the magazine
(6) Hole for cylinder pin of the push mechanism
(7) Longhole for cylinder pin to center the magazine
(8) Pushbutton for engaging the magazine at the nozzle changer
7 Station Enlargements User Manual SIPLACE CA
7.1 Nozzle Changer Edition 08/2011 EN
434
7.1.2.6 Operation
When you fill a magazine with a certain nozzle type for the first time, attach an adhesive label
to identify the type.
NOTE 7
Fill the magazines off the machine and always replace complete magazines. 7
Open the locking plate and place the nozzles in the nozzle holders.
Close the locking plate so that the nozzles cannot drop out of the magazines.
CAUTION 7
Magazines may only be filled if all the nozzles on the Collect&Place CA head have been
placed back in their magazines. 7
NOTE 7
Avoid letting components drop onto the magazines. This can cause the locking plate to jam.
You should therefore regularly clean the magazines and free locations.
Programming the nozzle changer is described in the SIPLACE Pro user manual.
7.1.2.7 Changing a Magazine
Press the lever (item 1 in fig. 7.1 - 8), to release the magazine from the pushbutton ball fix-
tures (item 5 in fig. 7.1 - 8
). Lift the magazine off the base.
WARNING 7
If the lever protrudes above the magazine (item 1 in fig 7.1 - 8
), this can cause a placement head
crash. You should therefore make sure that the lever does not protrude over the magazines.