00195941-03-UM SiplaceCA-EN.pdf - 第349页
User Manual SIPLACE CA 5 Tasks on the Machine Edition 08/2011 EN 5.4 Performing Inspections 349 5.4.6 Using Spindles for Large T ape Reels 5 5 Fig. 5.4 - 4 Component trolley , SIPLACE X-series, with tape container and sp…
5 Tasks on the Machine User Manual SIPLACE CA
5.4 Performing Inspections Edition 08/2011 EN
348
5.4.5 Inserting Partition Plates into the Tape Container
The partition plate has different edges and can be inserted into the tape container in two ways.
When using spindles, the partition plate recesses for the spindles should face upwards (see
item 4 in fig. 5.4 - 3
). If you are not using spindles, the rounded edge of the partition plate should
face upwards (see item 5 in fig.
5.4 - 3
).
Insert the partition plates as shown in fig. 5.4 - 3 and take into account that the smallest pitch
for the tape container is a 2-fold pitch. This will help avoid placement errors.
Check that the partition plates engage in the same positions on the three guide rails. Other-
wise the partition plate will be offset or bent.
5
Fig. 5.4 - 3 Partition plates in the tape container
(1) Guide rail for the partition plates
(2) Waste bin for unused tape
(3) Tape container
(4) Position of the partition plate when spindles are used
(5) Position of the partition plate when no spindles are used
(6) Sliding surfaces for the tape reels
User Manual SIPLACE CA 5 Tasks on the Machine
Edition 08/2011 EN 5.4 Performing Inspections
349
5.4.6 Using Spindles for Large Tape Reels
5
5
Fig. 5.4 - 4 Component trolley, SIPLACE X-series, with tape container and spindle
(1) Component trolley
(2) Position of the spindle
(3) Waste bin for unused tape
(4) Tape container
(5) Partition plate
(6) Spindle (enlarged)
Note: 5
X-series component trolleys do not generally need spindles. However, if the "Time-out" error
message occurs increasingly on the X feeder module, we recommend that you do use spindles.
5 Tasks on the Machine User Manual SIPLACE CA
5.5 Configuring Feeders Edition 08/2011 EN
350
5.5 Configuring Feeders
5.5.1 Handling Feeders
Feeder modules are precision devices. You should therefore handle the feeder modules with care.
Avoid bumping feeder modules into obstacles.
Do not drop the feeder modules.
Always use suitable tools for preventive maintenance.
5.5.2 Collect X-Feeder Modules from the Component Table
5
Fig. 5.5 - 1 Collect X-feeder modules from the component table
(1) Removal handle
(2) Status display
(3) LCD display
(4) Latch for locking the X feeder modules