00196044-05 - sg x und x4i fse_en.pdf - 第21页
Operational Safety Safety of Operators and Other Persons Safety Instructions S tudent Guide (FSE) SIPL ACE X Series and X4I Edition 01/2009 EN Operational Safety 21 2 Operational Safety See also: J 14.1.4 Operational Saf…
General
FSUSXS - Course Description
Student Guide (FSE) SIPLACE X Series and X4I
General Edition 01/2009 EN
20
1.2 FSUSXS - Course Description
Course type: SIPLACE upgrader training for X series
Target group: FSE and internal personnel
Requirements: SIPLACE X series training with SW701
Course duration: 5 days
Course location: SIPLACE training center Munich
Course objective: The course participants should already know the various assemblies in the
SIPLACE X machines, their differences to SIPLACE X4I, plus their general
functions. They should be able to install the SW70x software and use the new
functions. The participants should be able to completely calibrate the
machine. In addition, they should be familiar with the CPP placement head,
its reference run, placement sequences and the various placement modes.
The participants should be able to localize and fix minor errors. They should
also be able to replace spare parts on the placement head professionally,
service the placement head and ensure that the machine is in the correct
state for placement.
Operational Safety
Safety of Operators and Other Persons Safety Instructions
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN Operational Safety
21
2 Operational Safety
See also:
J
14.1.4 Operational Safety [
J
546]
2.1 Safety Instructions
The following safety instructions are only an excerpt from the chapter "Operational Safety" in the
SIPLACE user manual.
2.1.1 Safety of Operators and Other Persons
Machine operators must only carry out work for which they have been adequately trained and with which
they are totally familiar.
2.1.2 Safety of Plant and Equipment
Never make changes, however minor, unless you are totally aware of the effect they will have on the
overall functioning of the system.
The stations must always be set up, retooled and maintained by appropriately trained personnel.
Only use original spare arts and authorized accessories from Siemens AG. The use of other parts
will affect safety and will invalidate the liability for any consequential damage.
Do not make modifications to the safety equipment. Never bridge protective switches or remove
protective devices.
ATTENTION:
Any staff working on the machine must be familiar with the safety instructions in this user manual
and observe these at all times.
WARNING:
The system is electrically driven. When electrical devices are in use, certain parts carry
dangerous voltage levels.
X Switch off at the main switch and disconnect the placement system from the power supply
before carrying out any work on live components.
X Lock the machine.
X There is a risk of death, severe injury and/or considerable damage to equipment if these
instructions are not followed.
Operational Safety
Warning Labels Warning Labels W201, W203, W204 and W210 on the Machine
Student Guide (FSE) SIPLACE X Series and X4I
Operational Safety Edition 01/2009 EN
22
2.2 Warning Labels
2.2.1 Warning Labels W201, W203, W204 and W210 on the Machine
The warning labels are made from soft PVC film, and are abrasion-proof, light-fast and resistant to water
and weathering. Their design meets the requirements of ISO 3864-2 and ANSI Z535.4.
2-1: Warning labels W201, W203, W204 and W210 on the placement system - part 1
W201, article no. 03009338-01 (quantity per machine: 1)
W203, article no. 03009342-01 (quantity per machine: 4)
W204, article no. 03009343-01 (quantity per machine: 8)
W210, article no. 03009350-01 (quantity per machine: 2)