00196044-05 - sg x und x4i fse_en.pdf - 第609页
MTC2 Downloadi ng Parameter Sets Masterdrives S tudent Guide (FSE) SIPL ACE X Series and X4I Edition 01/2009 EN MTC2 613 14.4.5.3 St art Drive Monitor X Connect the cabel (seria l interface) betw een the Masterdrives and…
MTC2
Masterdrives Downloading Parameter Sets
Student Guide (FSE) SIPLACE X Series and X4I
MTC2 Edition 01/2009 EN
612
14-69: Computer requirements
X Select
Next
.
14-70: User registration
X Select
Next
.
14-71: Select the target drive, on which you wish to install the program.
X Select
Next
.
MTC2
Downloading Parameter Sets Masterdrives
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN MTC2
613
14.4.5.3 Start Drive Monitor
X Connect the cabel (serial interface) between the Masterdrives and Servicenotebook.
X Doubleclick on the icon
Drive Monitor
14-72: Select the software components Drive Monitor and Simovert .
X Select
Next
.
X Software installation will be started.
X Shutdown the computer and start again.
NOTE:
During the installation, the software create an ikon on the desktop.
X Create a
standard configuration file with the
ending .dnl
(see diagram on left), with the
parameters shown in the diagram below.
MTC2
Masterdrives Downloading Parameter Sets
Student Guide (FSE) SIPLACE X Series and X4I
MTC2 Edition 01/2009 EN
614
X Select the
Drive
and the operating software for the drive.
X Select
OK
X Select
Online EEPROM
(see diagram above).
If the settings for the serial interfaces at the master drive and notebook are the same, you will now be
connected online to the drive.
To check the serial interface in the Drive Monitor software, go to
TOOLS
-->
ONLINE SETTINGS
.
ATTENTION:
Select the operating software 1.5 for the MTC 1!
X Select
Save.
ATTENTION:
All parameters which you change now will be send to the drive directly and they are immediately
active.