00196044-05 - sg x und x4i fse_en.pdf - 第517页

Head Modularity Production requirements Head Modularity S tudent Guide (FSE) SIPL ACE X Series and X4I Edition 01/2009 EN Head Modularity 521 13-3: Decision criteria for selection of position and camera type s of CPP hea…

Head Modularity

Head Modularity Production requirements

Student Guide (FSE) SIPLACE X Series and X4I

Head Modularity Edition 01/2009 EN

520

13.3 Head Modularity

13.3.1 Production requirements

Which decisions must be taken before head exchange?

13-2: Decisions before head exchange

NOTE: Reconfiguration of a SIPLACE X machine

The new configuration of the SIPLACE X machine should be maintained for a longer production

time for that product and should not be changed again on a weekly basis, as machine

reconfiguration and recalibration can take at least a day, depending on the machine type.

NOTE:

When using mixed placement, you need to decide which camera type is to be used for the CPP

head to achieve the widest possible component spectrum.

Head Modularity

Production requirements Head Modularity

Student Guide (FSE) SIPLACE X Series and X4I

Edition 01/2009 EN Head Modularity

521

13-3: Decision criteria for selection of position and camera types of CPP head

NOTE:

For the option Head Modularity, use the retrofitting guide "Head Reconfiguration Kits".

Head Modularity

Head Modularity Head exchange

Student Guide (FSE) SIPLACE X Series and X4I

Head Modularity Edition 01/2009 EN

522

13.3.2 Head exchange

13.3.3 Calibration

SIPLACE X C&P

X Calibrate zero point correction both gantries.

X Calibrate PCB camera

X Calibrate C&P head

X Component Camera

 Segment offset 2

 Segment offset 1

X Calibrate nozzlechanger (inclusive automatic pick up height)

NOTE:

See Chapter "Calibration".