00196044-05 - sg x und x4i fse_en.pdf - 第614页

MTC2 Room for Your Sketches and Notes Er ror messages issued via the station S tudent Guide (FSE) SI PL ACE X Series and X4I MTC2 Edition 01/2009 EN 618 14.5 Room for Y our Sketches and Notes

MTC2

Error messages issued via the station Masterdrives

Student Guide (FSE) SIPLACE X Series and X4I

Edition 01/2009 EN MTC2

617

14.4.6 Error messages issued via the station

Alarms and faults on the master drive

 A140, A141: Axis blocked, does not move easily, check and remove any obstruction.

 FF01: Time overrun

 FF04: A fault has occurred during the RAM test.

 FF05: A fault has occurred during the EPROM test.

 FF13: A version conflict has occurred between the firmware and the hardware.

 F002: The monitoring time has expired. The DC intermediate circuit voltage has not reached the

setpoint (3s) (can be ignored).

 F006: Intermediate circuit voltage too high. If this fault occurs during the startup phase: Press the

SIPLACE start button.

During operation: Contact the SIEMENS service team.

 F008: The lower limit value (76%) was undershot (can be ignored).

Press the SIPLACE start button.

 F011: Short circuit

 F015: Axis blocked, does not move easily during reference run

 F020: Motor temperature monitoring triggered.

 F021: Motor blocked, does not move easily. (I2t monitoring for the motor)

 F023: Overtemperature master drives:

Ventilation locked, wire break at sensor.

 F035: Axis in the limit switch

 F041: A fault has occurred during the storage of values in the EEPROM.

 F051: Fault at resolver or cable disconnected.

 F082: Telegram fault - no new process data received. Replace the assembly.

 F085: A fault has occurred during initialization of the controller assembly in the master drives.

See also:

14.2.2 Incorporating the MTC in the SIPLACE station [

J

555]

NOTE:

Alarm messages will begin with „Axxx“. An alarm cannot be acknowledged.

It is automatically deleted once the cause has been eliminated.

NOTE:

Fatal errors will begin with „FFxx“. Fatal errors are serious hardware or software errors which

no longer permit normal operation of the Master drives. They only appear on the PMU in the

form "FF<No>". The software is re-booted by actuating any key on the PMU.

NOTE:

Fault messages will begin „Fxxx“. If a fault message is not reset before the electronic supply

voltage is switched off, then the fault message will be present again when the electronic supply

is switched on again.

MTC2

Room for Your Sketches and Notes Error messages issued via the station

Student Guide (FSE) SIPLACE X Series and X4I

MTC2 Edition 01/2009 EN

618

14.5 Room for Your Sketches and Notes

MTC2

Error messages issued via the station Room for Your Sketches and Notes

Student Guide (FSE) SIPLACE X Series and X4I

Edition 01/2009 EN MTC2

619