00196044-05 - sg x und x4i fse_en.pdf - 第584页

MTC2 MTC2 Calibration and Settings Adjustments Lifting Axes S tudent Guide (FSE) SI PL ACE X Series and X4I MTC2 Edition 01/2009 EN 588 14.3.3.3 Cassette guide rails T ools and Equipment  1 set of Allen keys Prep aratio…

100%1 / 632
MTC2
Adjustments Lifting Axes MTC2 Calibration and Settings
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN MTC2
587
Checking and setting the stopper bars, bottom
14-50: Guide rails, bottom
X Move the doors fully down
X Remove the side covers
X Set the position of the guide rails until they are
approx. 0.5 through 1mm away from the
WTCs.
WARNING:
The stopper bar and guide rail must
under no circumstances touch the
WTCs!
Legend
1. Guide rails
2. Fastening screws
MTC2
MTC2 Calibration and Settings Adjustments Lifting Axes
Student Guide (FSE) SIPLACE X Series and X4I
MTC2 Edition 01/2009 EN
588
14.3.3.3 Cassette guide rails
Tools and Equipment
1 set of Allen keys
Preparations
X Empty the MTC2 completely (see the User Manual).
X Prepare an empty cassette XL.
Setting the cassette guide rails
X Move the lifting axis into the refill position for cassette 1-> check the zero offset.
X Loosen the securing screws on both cassette guide rails.
X Tighten the securing screws of the inner cassette guide rail at the position in which the cassette can
still be inserted into the tower smoothly.
X Position the second cassette guide rail by means of the cassette parallel to the first cassette, so that
the cassette can be moved easily but without any lateral play. Tighten the securing screws here as
well.
X Check the setting of the other refill positions. -> "Check the refill positions“). If necessary, correct the
position of the cassette guide rails which has been set.
NOTE:
An empty cassette is needed to set the cassette guide rails.
14-51: Setting the cassette guide rails
Legend
1. Cassette XL in the refill position for tower 1
2. Cassette in the refill position for tower 2
3. Cassette guide rails for tower 1
4. Cassette guide rails for tower 2
MTC2
Adjustments feed axes MTC2 Calibration and Settings
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN MTC2
589
14.3.4 Adjustments feed axes
14-52: Overview of the feed axes (cover plates and belt covers removed)
Legend
1 Feed axis, tower 1 5 Toothed belt
2 Feed axis, tower 2 6 Disengaging mechanisms
3 Servo motors of the feed axes 7 Driver
4Drive belt