00196044-05 - sg x und x4i fse_en.pdf - 第64页

Overview Overview of Components Axis Unit with A364 S tudent Guide (FSE) SI PL ACE X Series and X4I Overview Edition 01/2009 EN 64 3.2.5.2 Axis Controller Board A364

Overview

Axis Unit with A364 Overview of Components

Student Guide (FSE) SIPLACE X Series and X4I

Edition 01/2009 EN Overview

3.2.5 Axis Unit with A364

The axis unit contains the servo boards, axis controller boards, power supplies (+/-15V,+5V) and ballast

circuit. The flexible axis unit is equipped with the correct servo and axis boards for the machine type and

head configuration concerned. Depending on the machine type, there will be either one or two axis units

in the machine.

See also:

13.9.1 Axis Unit A364 [

J

533]

3-13: Configuration of axis unit X4I with C&P20A heads

Legend

1. Power supply +/- 15, +5 V

2. Ballast circuit, only in axis unit PA2

3. Power supply +/- 15V

4. Fan unit (blows downwards)

5. Axis card A364 for gantry 1/2

6. Axis card A364 for gantry 4/3

7. Servo amplifier X axes

8. Servo amplifier Y axes

9. Brake board for each X axis and Y axis

10. Servo star axis (2x)

11. Servo Z axis (2x)

12. DC/DC converter DP drives (2x)

13. Placement area 1 gantry 1 (top half)

14. Placement area 1 gantry 4 (bottom half)

Overview

Overview of Components Axis Unit with A364

Student Guide (FSE) SIPLACE X Series and X4I

Overview Edition 01/2009 EN

3.2.5.2 Axis Controller Board A364

Overview

Changeover Table Components Overview of Components

Student Guide (FSE) SIPLACE X Series and X4I

Edition 01/2009 EN Overview

3.2.6 Changeover Table Components

SIPLACE X machines with SW70x only support the new generation of X feeders and X component

changeover tables. This changeover table does not have any electronic assemblies, such as the

communication unit for feeder supply and control in the previous tables. The power supply for the feeders

is without contact, via an inductive interface on the docking unit, directly to the feeders. Control and

communication between the feeder control unit (FCU) and the feeders is provided via two optoelectronic

channels (light conductors). The FCU is connected to the computer unit in the machine via the machine

CAN Bus. Only X tables can be used on the machines.

3.2.6.1 Docking and Undocking

Each X feeder table has 40 slots for 8 mm X feeders, giving a total capacity of 160 individual tracks on

4 changeover tables.

3-14: Shows the button for docking and undocking changeover tables

Legend

1. Button for docking and undocking changeover

tables

 T = transport direction

The changeover table is automatically docked at

the machine, with two pneumatic cylinders. For

docking, the changeover table is moved up to the

docking unit, the hood is closed and the button is

pressed. For undocking, the cover is opened and

the button is pressed again.

NOTE: From software 70x

X machines from software 70x only support X tables.

NOTE: X4I

Due to the rotated gantries, there are only 34 tracks available at locations 2 and 4 of the X4I.