00196044-05 - sg x und x4i fse_en.pdf - 第524页
Head Modularity Preperation head plate CPP S tudent Guide (FSE) SI PL ACE X Series and X4I Head Modularity Edition 01/2 009 EN 528 13.7 Preperation head plate 13.7.1 CPP NOTE: This head p late is fitted in machines from …
Head Modularity
Calibration Head Modularity C&P20A to CPP Head
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN Head Modularity
527
X Check the length of the centering pins (2) before fitting a CPP head.
This may only extend 4.0 mm (tolerance: -0.2 mm) from the head plate.
X Remove the grub screws (3) from the head plate.
X Seal the drilled holes on the C&P20A with these grub screws (3).
Seal the thread of the grub screws with Loctite 511.
X Fit the CPP head with 4 M4x18 and 2.7 Nm screws.
ATTENTION:
If the centering pins extend by more than 4.0 mm from the head plate, the incremental disk of
the star axis (glass) could be irreparably damaged during assembly of the CPP head!
Legend
1. Rear view
2. Front view
3. Connection for holding circuit
4. Connection for return cylinder
5. Connection for pressure control valve
X Connect the flat ribbon cable and the
pneumatic hoses and run correctly.
Head Modularity
Preperation head plate CPP
Student Guide (FSE) SIPLACE X Series and X4I
Head Modularity Edition 01/2009 EN
528
13.7 Preperation head plate
13.7.1 CPP
NOTE:
This head plate is fitted in machines from number B079 onwards. These differ only in the
extension fitted to the left side.
ATTENTION:
Before a CPP head is fitted, always check the length of the centering pins. These centering pins
may only extend out of the head plate by a maximum of 4.0 mm (tolerance: -0.2 mm). If these
are longer, the incremental disc for the star could be irreparably damaged.
Head Modularity
C&P20A Preperation head plate
Student Guide (FSE) SIPLACE X Series and X4I
Edition 01/2009 EN Head Modularity
529
13.7.2 C&P20A