JX-350_EPU使用说明书.pdf - 第51页
EPU Instruction M anual C hapter 4 Creating a Production Progr am 4-3 4.1.1 Proce dure for crea ting a production progra m Create a prog ram in the or der of PW B → Placement → Com ponent → Pic k Y ou can enter only alph…
EPU Instruction Manual Chapter 4 Creating a Production Program
4-2
When you start up the Program Edit module, the following “Program Editor” screen appears
as shown below.
- In JX-350 EPU, the “Machine Operation (M)” function cannot be selected.
- In JX-350 EPU, a multiple start (2 programs) of Program Editing can be
performed. In an environment having few system resources, this multiple
start cannot be performed.
- The size of the production program can be increased by optimization.
Have it in mind when saving the production program into a FD or the like.
- In EPU, data cannot be obtained by teaching. The data of a part of the
program can be obtained by teaching. Some data can be obtained only by
teaching. Therefore, there are portions in this instruction manual where a
data obtaining method by teaching is explained or described.
However, since data is created out of the equipment in the case of EPU,
data cannot be obtained by teaching. For the data requiring teaching,
perform teaching in the equipment proper.
CAUTION
CAUTION
EPU Instruction Manual Chapter 4 Creating a Production Program
4-3
4.1.1 Procedure for creating a production program
Create a program in the order of PWB → Placement → Component → Pick
You can enter only alphanumeric characters from a keyboard.
Type of data Description
PWB This covers overall PWB data such as PWB outer dimensions and the coordinates of Board
Offset Correction (BOC) mark position.
Placement This covers coordinates of the placement position, component names to be placed and others.
Component The data including component dimensions and packaging style required for laser centering is
handled.
Pick This covers the data on positions of components supplied by a tape feeder, stick feeder etc.
You cannot open the next data screen until you completely create the data you are
supposed to create first: for example, you cannot open the “Placement” data screen
if you have not created “PWB data” completely.
EPU Instruction Manual Chapter 4 Creating a Production Program
4-4
4.1.2 PWB data
PWB data consists of five items: “Basic setting,” “Dimension setup,” “Circuit layout,”
“PWB Conveyor” and “Ex. Bad Mark”.
• Basic setting: Enter the basic PWB configuration here.
• Dimension setup: Enter the detailed dimensions of a PWB. The displayed items
vary depending on the settings of the “Basic setting” items.
• Circuit layout: Enter the position, angle of a circuit and PWB configuration.
When you use a JX-350, you can select this only if you select the
“Non-matrix circuit” radio button on the “Dimension setup” tab.
When you use a JX-350, you can select this only if you select the
“Used” radio button for the menu item “Circuit Mapping” on the
“Basic setting” tab, and the “Matrix circuit” radio button or the
“Non-matrix circuit” radio button on the “Dimension setup” tab.
You can enter these items only if you select “Non-matrix circuit” as
the “PWB configuration” on the “Basic setting” screen.
• PWB Conveyor: Make the detailed settings of the conveyor.
• Ex. Bad Mark: Enter the coordinates of a bad mark on each circuit when you are
to use an extended bad mark.