88192277-01-19 - Micron Technical Reference V9 Volume 4.pdf - 第145页
TRANSPORTATION - MINOR RELOCATION TRANSIT BRACKET INSTALLATION Chapter Issue 4, May 19 Technical Reference Manual 41.3 1. Screw two M8 chase studs (1) into the right hand side of the chase, engaging approximately 15mm of…
TRANSPORTATION - MINOR RELOCATION
TRANSIT BRACKET INSTALLATION
41.2 Technical Reference Manual Chapter Issue 4, May 19
TRANSIT BRACKET INSTALLATION
The figure below shows the transit brackets fully assembled for part identifica-
tion. Do not assemble off the machine, use the following procedure to assemble
the transit brackets on the machine.
Figure 41-1 Front and Rear Transit Brackets
NOTE
Item 5, the Left Chase Bracket is fitted upside down on dual lane machines.
Item Description Item Description
1 M8 Chase Stud 6 Transit Adjustment Screw Lock Nut
2 Front/Rear Transit Bracket 7 Transit Adjustment Screw
3 M8 Nut 8 Adaptor Bracket
4 M8 Washer 9 M5 Cap Head Screw
5 Left Chase Transit Bracket 10 M5 Washer
9
1
2
3
4
5
6
7
8
10
TRANSPORTATION - MINOR RELOCATION
TRANSIT BRACKET INSTALLATION
Chapter Issue 4, May 19 Technical Reference Manual 41.3
1. Screw two M8 chase studs (1) into the right hand side of the chase,
engaging approximately 15mm of thread and secure with M8 nuts (3) and
M8 washers (4).
2. Place a left chase transit bracket (5) over the hole on the left hand side of
the chase aligned to the front X actuator.
3. Place a left chase transit bracket (5) over the hole on the left hand side of
the chase aligned to the rear X actuator.
4. Screw two M8 chase studs (1) through the holes in the left chase transit
brackets (5) and into the holes in the chase, engaging approximately 15mm
of thread and secure with M8 nuts (3) and M8 washers (4).
5. Ensure that an M8 nut (3) is fitted to all four M8 chase studs (1) and is
approximately 50mm down from the top of the M8 chase stud (1).
6. Place an M8 washer (4) on all four M8 chase studs (1).
7. Loosely fit the rear chase transit bracket to the rear of the left hand printhead
using an M6 cap head screw (13) and M6 washer (14).
TRANSPORTATION - MINOR RELOCATION
TRANSIT BRACKET INSTALLATION
41.4 Technical Reference Manual Chapter Issue 4, May 19
Figure 41-2 Rear Chase Transit Bracket
8. Adjust the angle of the rear chase transit bracket (12) to align the transit
adjustment screw (11) to the centre of the chase/ASM. Tighten the M6 cap
head screw (13).
9. Adjust the transit adjust screw (7), on both the left chase transit brackets (5),
and the transit adjustment screw (11) on the rear chase transit bracket (12),
so that the chase is moved approximately 5mm away from all three actuator
shafts.
10. Lock the transit adjustment screws in position with the transit adjustment
screw lock nuts (6) and (15).
11. Place the front and rear transit brackets (2) over the M8 chase studs (1).
Item Description Item Description
11 Transit Adjustment Screw 14 M6 Washer
12 Rear Chase Transit Bracket 15 Transit Adjustment Screw Lock Nut
13 M6 Cap Head Screw
View on Right Hand Underside
11
12
14
15
13