88192277-01-19 - Micron Technical Reference V9 Volume 4.pdf - 第175页
TRANSPORTATION - MAJOR RELOCATION TRANSIT BRACKET AND SCREW INSTALLATION Chapter Issue 5, Nov 19 Technical Reference Manual 42.9 The figure below shows the transit brackets fully assembled for part identifica- tion. Do n…
TRANSPORTATION - MAJOR RELOCATION
TRANSIT BRACKET AND SCREW INSTALLATION
42.8 Technical Reference Manual Chapter Issue 5, Nov 19
Squeegee
Mechanism Transit
Screws
1. By hand, gently raise the squeegee mechanism until the slots in the squee-
gee mechanism aligns with the holes in the squeegee mount.
2. Fit the two squeegee transit screws, one either side of the squeegee
mechanism, without over tightening the screw.
NOTE
The squeegee transit screws are designed to restrict the movement of the
squeegee mechanism and not to clamp the squeegee mechanism against
the squeegee mount.
3. Protect the front of the squeegee mechanism with a piece of card (300mm
x 180mm approximately) secured using cable ties.
Chase Brackets The chase transit brackets include the following:
• Front Transit Bracket
• Rear Transit Bracket
• Rear Chase Transit Bracket
Squeegee Transit Screws
Squeegee Mechanism Squeegee Mount
TRANSPORTATION - MAJOR RELOCATION
TRANSIT BRACKET AND SCREW INSTALLATION
Chapter Issue 5, Nov 19 Technical Reference Manual 42.9
The figure below shows the transit brackets fully assembled for part identifica-
tion. Do not assemble off the machine, use the following procedure to assemble
the transit brackets on the machine.
Figure 42-3 Front and Rear Transit Brackets
NOTE
Item 5, the Left Chase Bracket is fitted upside down on dual lane machines.
Item Description Item Description
1 M8 Chase Stud 6 Transit Adjustment Screw Lock Nut
2 Front/Rear Transit Bracket 7 Transit Adjustment Screw
3 M8 Nut 8 Adaptor Bracket
4 M8 Washer 9 M5 Cap Head Screw
5 Left Chase Transit Bracket 10 M5 Washer
9
1
2
3
4
5
6
7
8
10
TRANSPORTATION - MAJOR RELOCATION
TRANSIT BRACKET AND SCREW INSTALLATION
42.10 Technical Reference Manual Chapter Issue 5, Nov 19
1. Screw two M8 chase studs (1) into the right hand side of the chase,
engaging approximately 15mm of thread and secure with M8 nuts (3) and
M8 washers (4).
2. Place a left chase transit bracket (5) over the hole on the left hand side of
the chase aligned to the front X actuator.
3. Place a left chase transit bracket (5) over the hole on the left hand side of
the chase aligned to the rear X actuator.
4. Screw two M8 chase studs (1) through the hole in the left chase transit
bracket (5) and into the hole in the chase, engaging approximately 15mm
of thread and secure with M8 nuts (3) and M8 washers (4).
5. Ensure that an M8 nut (3) is fitted to all four M8 chase studs (1) and is
approximately 50mm down from the top of the M8 chase stud (1).
6. Place an M8 washer (4) on all four M8 chase studs (1).
7. Loosely fit the rear chase transit bracket to the rear of the left hand printhead
using an M6 cap head screw (13) and M6 washer (14).