88192277-01-19 - Micron Technical Reference V9 Volume 4.pdf - 第230页
TRANSPORTATION - MAJOR RELOCATION MACHINE HEIGHT AND LEVELLING 42.64 Technical Reference Manual Chapter Issue 5, Nov 19 Levelling and Positioning (Machine A) 1. Raise the rear cent re mounting foot (5) to the highest pos…
TRANSPORTATION - MAJOR RELOCATION
MACHINE HEIGHT AND LEVELLING
Chapter Issue 5, Nov 19 Technical Reference Manual 42.63
The height of each machine is governed by the external machines that it is to
be connected to and ranges from 840mm to 980mm. The height is measured
from the floor to the top of the transport belts.
The transport height may be adjusted as low as 830mm by removing the M24
full nut on each of the legs. In the event of the transport height being adjusted
above 839mm at a later date, the M24 full nut must be refitted. The locating
collar positions the machine accurately against the V-blocks on the Locator
Plate Assembly.
NOTE
To achieve reliable DEK SPC testing and Cp/Cpk results, the machine legs must
be secured correctly to the frame to increase the rigidity of the machine.
Height to Top
of Transport Belts
8 mm to 980mm95
View on Front of Machine
Transport Belts
Washer
Machine Frame
M24 Full Nut
Half Nut
Locating Collar
Leg Bolt
Foot
Half Nut
Leg Adjusting Nut
TRANSPORTATION - MAJOR RELOCATION
MACHINE HEIGHT AND LEVELLING
42.64 Technical Reference Manual Chapter Issue 5, Nov 19
Levelling and
Positioning
(Machine A)
1. Raise the rear centre mounting foot (5) to the highest position to avoid
contact with the floor plate.
2. Move machine A into position and align it with the downline machine using
two rectangular PCBs.
3. Using recommended lifting equipment, carefully raise the machine approx-
imately 10mm off the floor. Avoid any movement in direction X and Y.
4. Check the location blocks and V-blocks on the floor plate are free to move
in X and Y.
5. Check that all four stopper bolts are fully wound in.
Location Blocks x 2
Stopper Bolts
and locking nuts x4
V-Block x 2
Location Block Fixing Screws x 4
Plan Floor PlateView on Machine
TRANSPORTATION - MAJOR RELOCATION
MACHINE HEIGHT AND LEVELLING
Chapter Issue 5, Nov 19 Technical Reference Manual 42.65
6. Place the floor plate under foot (3) and foot (4) of machine A ensuring the
orientation of the floor plate is correct (V-blocks upline).
7. Ensure the floor plate is positioned in line with foot (3) and foot (4) and
parallel to the rear of the printer (shown above).
8. Lower the machine onto the floor plate, ensuring foot (3) and foot (4) are
positioned correctly on the plate and clear of the location and V-blocks.
9. Place foot (6) under the front of the machine in the centre.
10. Check the orientation of foot (6) as shown above.
NOTE
Avoid the seam weld to ensure the machine is properly supported.
11. Raise the front centre levelling foot (6) to make contact with the machine.
12. Raise the front left foot (1) and front right foot (2) so they are not in contact
with the floor and the machine is supported on the centre mounting foot (6).
=
=
LINE DIRECTION
DOWNLINE
UPLINE
=
=
MACHINE
B
MACHINE
A
Seam WeldLevelling Foot (6)
Front below FrameView Machine