88192277-01-19 - Micron Technical Reference V9 Volume 4.pdf - 第272页
TRANSPORTATION - MAJOR RELOCATION MACHINE ASSEMBLY 42.106 Technical Reference Manual Chapter Issue 5, Nov 19 2. Move the angle brackets aw ay from the support plate . 3. Remove the rear cover of the machine (front cove r…
TRANSPORTATION - MAJOR RELOCATION
MACHINE ASSEMBLY
Chapter Issue 5, Nov 19 Technical Reference Manual 42.105
External Solvent Tank
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. SAFETY GLOVES MUST BE WORN.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. EYE PROTECTION MUST BE WORN.
NOTE
Changing solvent types may cause unexpected chemical reactions and degra-
dation within the solvent feed tube. ASM recommend that if the solvent is
changed to a different type, the solvent feed tube, from the solvent tank to the
cleaner pump, is replaced.
The external solvent tank may be fitted to the rear or the side of the machine.
The support plate on the external solvent tank is configured differently from side
or rear fitting due to baffle plates covering the cooling fans at the rear of the
machine.
To fit the external solvent tank carry out the following:
1. Configure the support plate of the external solvent tank for rear or side fitting
to the machine.
Rear Fitting Side Fitting
Support Plate Support Plate
TRANSPORTATION - MAJOR RELOCATION
MACHINE ASSEMBLY
42.106 Technical Reference Manual Chapter Issue 5, Nov 19
2. Move the angle brackets away from the support plate.
3. Remove the rear cover of the machine (front cover on type 4 machines).
4. Place the external solvent tank on the floor beneath its intended location.
5. Supporting its weight, lift the external solvent tank and locate the support
plate on the machine base frame, as shown in the graphic below:
6. Place a full solvent container into the external solvent tank.
7. Remove the cap from the solvent container.
8. Locate the combined solvent container cap and 4mm tubing, inside the
machine.
9. Pass the cap through the hole in the external solvent tank base plate, from
underneath.
Support Plate
Angle Brackets
Support Plate Machine Base Frame (Cross Section)
NOTE
Baffles removed for clarity
TRANSPORTATION - MAJOR RELOCATION
MACHINE ASSEMBLY
Chapter Issue 5, Nov 19 Technical Reference Manual 42.107
10. Fit the combined cap and 4mm tubing to the solvent container.
11. Connect the cable from the external solvent tank to 9SK69 on the external
services panel.
12. Fit the rear cover (front cover on type 4 machines).
Solvent Container Cap
Base Plate
View on Rear of Machine
POWER ON
PART No. 160740
M/C AVAILABLE
BOARD AVAILABLE
BOARD PASS
D
O
W
N
L
IN
E
BOARD AVAILABLE
BOARD PASS
M/C AVAILABLE
U
P
L
IN
E
FMI POD
Solvent Fluid
Connector
Solvent Sensor
9SK69