88192277-01-19 - Micron Technical Reference V9 Volume 4.pdf - 第260页

TRANSPORTATION - MAJOR RELOCATION MACHINE ASSEMBLY 42.94 Technical Reference Manual Chapter Issue 5, Nov 19 Fit ProFlow A T x System Mount T o fit the ProFlow A Tx system mount to the machine, carry out th e following pr…

TRANSPORTATION - MAJOR RELOCATION

MACHINE ASSEMBLY

Chapter Issue 5, Nov 19 Technical Reference Manual 42.93

nism. Once the unit is slid fully home, it is secured by closing the locking clip.

6. Connect both curly air lines to the self-seal pneumatic connectors situated

either side of the ProFlow printhead mechanism, figure in Step 7 refers.

7. Fit the electrical connection 9SK61 ProFlow Paste Level Sensor from the

ProFlow unit into the connector (9PL61) located on the left hand side of the

ProFlow, on the print carriage, figure in Step 2 refers.

NOTE

a. If Time to Go is an option, an amplifier is connected to 9PL61 and the

connection is made to 9PL62 on the amplifier.

b. This electrical connection informs the machine of ProFlow fitment and

must always be connected whilst the ProFlow unit is fitted otherwise

damage may occur if machine is run.

ProFlow ATx

Fitting To fit ProFlow ATx to the machine, carry out the following procedures:

• Fit ProFlow ATx System Mount

• Fit Transfer Head

• Level Transfer Head

• Fit Print Medium Cartridge

Mount Plate

TRANSPORTATION - MAJOR RELOCATION

MACHINE ASSEMBLY

42.94 Technical Reference Manual Chapter Issue 5, Nov 19

Fit ProFlow ATx

System Mount

To fit the ProFlow ATx system mount to the machine, carry out the following

procedure:

1. Locate the four captive mount screws and two locator dowels on the rear of

the mount plate of the ProFlow ATx system mount assembly.

2. Lower the ProFlow ATx system mount beam by manually turning the Z-axis

motor pulley counter-clockwise. This action reveals the four captive screw

heads located on the front face of the mount plate.

NOTE

The captive screws may be hidden behind the components on the front of

the mount assembly. Move the beam down until they are fully revealed.

3. Locate the two locator dowel holes on the front face of the print carriage.

View on Rear of ProFlow Mount

Mount Plate

Captive Mount

Screw (4 Positions)

Locator Dowel

(2 Positions)

Z-Axis Motor

Pulley

Locator Dowel Holes

View on Front Left Corner

TRANSPORTATION - MAJOR RELOCATION

MACHINE ASSEMBLY

Chapter Issue 5, Nov 19 Technical Reference Manual 42.95

4. Fit the ProFlow ATx system mount mechanism to the print carriage, ensuring

that both locating dowels fit into the locator dowel holes.

NOTE

Ensure the cables and air feed lines are free from moving parts that may

prevent the ProFlow ATx mount from being secured to the print carriage.

5. Secure the ProFlow ATx system mount to the print carriage; tighten the four

captive screws on the mount plate, using the 4mm T-bar Allen key supplied

(205973).

6. Using a crosshead screwdriver, attach the drag chain carrying the left hand

side cable and air feed connectors to the left hand side of the print carriage.

7. Connect the following to the ProFlow ATx connections on the left hand side

of the print carriage:

• Conditioning Grid Motor Power (9PL96)

• Head Empty Sensor (9PL77)

• Print Medium Cartridge Air Feed

• ProFlow Home (9PL08)

• Z-axis Stepper Motor Power (9PL17)

• Print Medium Low Sensor and ProFlow Fitted Link (9PL61)

• Conditioning Grid Motor CAN (9PL98)

View on Print Carriage Top Face

Left Side Drag

Chain Screw