00196693-03_UM_SX4DX4_SR706_EN.pdf - 第186页
3 Technical data and assemblies User Manual SIPLACE SX4/DX4 3.10 Component trolleys on the SIPLACE SX4 From software version SC.706.xx Version 06/2012 EN 186 3.10.9 Used t ape chute 3 Fig. 3.10 - 10 Used tape chute for t…
User Manual SIPLACE SX4/DX4 3 Technical data and assemblies
From software version SC.706.xx Version 06/2012 EN 3.10 Component trolleys on the SIPLACE SX4
185
3.10.8.2 Maximum tape reel diameter in relation to the PCB conveyor height
3
PLEASE NOTE: 3
SIPLACE X series component trolleys do not generally need spindles. However, if the "Timeout"
error message occurs increasingly on the X feeder module, we recommend that you do use spin-
dles.
Without mount for the
additional tape reel
With mount for the
additional tape reel
PCB conveyor
height
of the component
trolley
Tape reel diameter Tape reel diameter
without spindle with spindle
900 mm 19" 17" 15"
930 mm 19" 19" 17"
950 mm 19" 19" 19"
3 Technical data and assemblies User Manual SIPLACE SX4/DX4
3.10 Component trolleys on the SIPLACE SX4 From software version SC.706.xx Version 06/2012 EN
186
3.10.9 Used tape chute
3
Fig. 3.10 - 10 Used tape chute for the component trolley docking unit
In accordance with the PCB conveyor height, the length of the used tape chute can be set so that
the tape cuttings are directly diverted into the waste tape container of the component trolley.
PLEASE NOTE 3
The used tape chute for the SIPLACE X series can only be installed on the component trolley
docking unit for the SIPLACE X series (see fig. 5.15 - 3, page 292).
User Manual SIPLACE SX4/DX4 3 Technical data and assemblies
From software version SC.706.xx Version 06/2012 EN 3.10 Component trolleys on the SIPLACE SX4
187
3.10.10 Empty tape duct on the component trolley docking unit
In the standard version, the empty tape duct can guide component tapes with a maximum pocket
height of 12 mm to the pneumatic tape cutter.
3
Fig. 3.10 - 11 Empty tape duct on the SIPLACE X series component trolley docking unit
(1) Inlet slot for the used tapes
(2) Outlet slot for the used tape above the pneumatic tape cutter
(3) Dividing plate for tapes < 12 mm (can be removed for tapes > 12 mm)
PLEASE NOTE
– The separating plate (item 3 in fig. 3.10 - 11
) can be removed for tape pockets higher than 12
mm.
Do not position feeder modules with shallow pockets immediately beside feeder modules with
deep pockets. The used tapes could overlap and build up.