00196693-03_UM_SX4DX4_SR706_EN.pdf - 第268页

5 Working with the machine User Manual SIPLACE SX4/DX4 5.9 Carrying out a sight check From softw are version SC.706.xx Version 0 6/2012 EN 268 5.9.5 Inserting sep arating plates in the t ape container  The separating pl…

User Manual SIPLACE SX4/DX4 5 Working with the machine

From software version SC.706.xx Version 06/2012 EN 5.9 Carrying out a sight check

267

5.9.4 Support for an additional tape reel

Fig. 5.9 - 2 Support for the additional tape reel

(1) Support for an additional tape reel, item no. 00141217-xx

(2) Mounting device for the support

X series feeder modules can process component tapes without problems if the lateral offset be-

tween the feeder module and the tape reel does not exceed 60 mm.

If a predefined setup means that the maximum permitted offset cannot be maintained, we recom-

mend that you use the mount for an additional tape reel (item 1). Simply insert the mount into the

holder (item 2) and push it until the offset is less than the maximum permitted value of 60 mm. The

component trolley has 5 holders in total. Each tape reel mount can hold 2 tape reels, which means

that up to ten 15" (381 mm) reels can be positioned above the tape container.

max. 60 mm

5 Working with the machine User Manual SIPLACE SX4/DX4

5.9 Carrying out a sight check From software version SC.706.xx Version 06/2012 EN

268

5.9.5 Inserting separating plates in the tape container

 The separating plate has different edges and can be inserted into the tape container in two

ways. If spindles are used, the recesses for the spindles in the separating plate point upwards

(see item 4 in fig. 5.9 - 3

). If you do not use spindles, the rounded edge of the separating

plate points up (see item 5 in fig. 5.9 - 3

 Insert the separating plates as shown in fig. 5.9 - 3 and remember that the smallest division

of the tape container is a 2x division. This will help avoid placement errors.

 Check that the separating plates engage in the same positions on the three guide rails. Oth-

erwise the separating plate will be offset or bent.

Fig. 5.9 - 3 Separating plates in the tape container

(1) Guide rail for the separating plates

(2) Waste tape container

(3) Tape container

(4) Position of the separating plate if spindles are used

(5) Position of the separating plate if no spindles are used

(6) Sliding support for tape reels

User Manual SIPLACE SX4/DX4 5 Working with the machine

From software version SC.706.xx Version 06/2012 EN 5.10 Setting up the feeder modules

269

5.10 Setting up the feeder modules

The following chapter shows diagrams of the SIPLACE SX4. However, setup of the X feeder mod-

ules on the SIPLACE SX4 changeover tables is basically identical to inspection of the DX tables/

DX changeover tables in the SIPLACE DX4.

5.10.1 Notes on handling feeder modules

Feeder modules are precision devices. You should therefore handle the feeder modules with care.

 Avoid bumping feeder modules into obstacles.

 Do not drop the feeder modules.

 Always use suitable tools for preventive maintenance.

5.10.2 Removing X feeder modules from the changeover table

Fig. 5.10 - 1 Removing X feeder modules from the changeover table

(1) Removal handle

(2) Status display

(3) LCD display

(4) Latch for locking the X feeder modules