00196693-03_UM_SX4DX4_SR706_EN.pdf - 第263页
User Manual SIPLACE SX4/DX4 5 Working with the machine From software version SC.706.xx V ersion 06/2012 EN 5.8 Changing shift 263 5.8.2 Safety instructions for em ptying the waste tape cont ainer 5 Fig. 5.8 - 1 Safety in…
5 Working with the machine User Manual SIPLACE SX4/DX4
5.8 Changing shift From software version SC.706.xx Version 06/2012 EN
262
5.8 Changing shift
5.8.1 Activities at shift change
Splice the tapes early. The feeder modules do not have to be refilled as soon as the new shift
starts. This minimizes extended down times.
At the shift change, pass important information on to the next operator. This includes, for in-
stance, changes to the placement program. Also read through the list of the descriptions of
the steps to take in section 5.12
, page 285.
Carry out a setup check.
Make sure that the feeder modules are equipped with the correct components, that they are
at the correct locations on the component trolley/DX tables/DX changeover tables and that
the conveyor increment is set correctly.
Clean the following line assemblies:
Empty the reject bin and carefully vacuum the area around the reject bin.
Carefully vacuum the nozzle changer, feeder modules and the component trolley/DX table.
Empty the waste tape container. Follow the safety instructions given in section 5.8.2, page
263
.
User Manual SIPLACE SX4/DX4 5 Working with the machine
From software version SC.706.xx Version 06/2012 EN 5.8 Changing shift
263
5.8.2 Safety instructions for emptying the waste tape container
5
Fig. 5.8 - 1 Safety instructions for emptying the waste tape container
The waste tape container must be pulled out of the component trolley for emptying. There is a risk
of catching your thumbs as you do so.
To avoid this risk, take hold of the underside of the grab recess on the waste tape container
with your fingers and place your thumbs on top of the grab recess.
Do NOT put your thumbs in the gap between the tape container and waste tape container as
you could catch your thumbs if you do.
5 Working with the machine User Manual SIPLACE SX4/DX4
5.9 Carrying out a sight check From software version SC.706.xx Version 06/2012 EN
264
5.9 Carrying out a sight check
The following chapter shows diagrams of the SIPLACE SX4. However, inspection of the X feeder
modules on the SIPLACE SX4 changeover tables is basically identical to inspection of the DX ta-
bles/DX changeover tables in the SIPLACE DX4.
5.9.1 Checking the X feeder modules
5
Fig. 5.9 - 1 Checking the X feeder modules
(1) Flap
(2) Blade
(3) Status display
(4) LCD display
5