00196693-03_UM_SX4DX4_SR706_EN.pdf - 第289页
User Manual SIPLACE SX4/DX4 5 Working with the machine From software version SC.706.xx Version 06/2012 EN 5.15 Docking the component trolley in or out 289 5.15 Docking the component trolley in or out The following chapte…
5 Working with the machine User Manual SIPLACE SX4/DX4
5.14 Refilling components From software version SC.706.xx Version 06/2012 EN
288
5.14 Refilling components
The online help contains information on refilling components with and without barcodes.
With tape feeder modules, make sure that you always splice on a new tape early enough so
that the feeder modules do not run out of components.
However, do not splice the tapes too early because if you wind the tape onto the new reel
after splicing the end of the old tape, the reel with the new tape may be overfilled. The tape
could then slip off the reel and become tangled. Under certain circumstances, this could
cause pick-up errors and prolonged down times.
User Manual SIPLACE SX4/DX4 5 Working with the machine
From software version SC.706.xx Version 06/2012 EN 5.15 Docking the component trolley in or out
289
5.15 Docking the component trolley in or out
The following chapter shows diagrams of the SIPLACE SX4. The component changeover tables
for the SIPLACE SX4 are docked and undocked in the exactly same way as the DX changeover
tables for the SIPLACE DX4.
5.15.1 Safety instructions for docking component trolleys in and out
Also follow the safety instructions given in section 2.6.3, page 62.
CAUTION
When docking and undocking, make sure that there are no body limbs in the travel area of the
component trolley. 5
WARNING 5
To prevent accidents (risk of crushing), the component trolley may only be docked in or out by
one person.
In addition, the component trolley can only be docked in if the protective
covers are closed.
There is a button at each location (1,2,3 and 4). The safety concept for the component trolley
changeover specifies that the operator should push this button at the relevant machine location,
to dock or undock the component trolley.
5 Working with the machine User Manual SIPLACE SX4/DX4
5.15 Docking the component trolley in or out From software version SC.706.xx Version 06/2012 EN
290
5
Fig. 5.15 - 1 Safety instructions for docking the component trolley in or out
In addition, the component trolley can only be docked in if the protective
covers are closed.
(1) Button for docking and undocking the component trolley at location
(T) Direction of PCB transport
5.15.2 Docking out the component trolley
Press the button on the respective machine location until the component trolley is completely
undocked.
Swivel the two handles up (item 1 in fig. 5.15 - 2).
(1)