Smart Gui - Algorithm Training Material_rev1.pdf - 第16页

Copyright © ViT rox All Rights Reserved . CR T ype Algorithm - Body 16 1. 3D Geometry Measure ● T ick this to enable the 3D Damaged inspection. ● Consists of minimum/maximum measure for length/width. ● Unit can be in % o…

CR Type Algorithm - Body

1. 3D Damaged Inspection

● Tick this to enable the 3D Damaged inspection.

● Inspection result will prompt out Coplan if the absolute difference

between the opposite boxes in vertical direction is more

Eg. for 40%

2. Damaged Location

● To adjust the location for the Damaged inspection boxes.

● The smaller the percentage, The inner the boxes towards the

centroid

3. Damaged Thres (um)

● Software will check the height of these 4 boxes, the component

will fail as “Damaged” if the absolute height different between

any one of the ROI's height and component height higher than

damaged threshold.

CR Type Algorithm - Body

1. 3D Geometry Measure

● Tick this to enable the 3D Damaged inspection.

● Consists of minimum/maximum measure for length/width.

● Unit can be in % or um.

2. Min Length Measure

a. Disable to turn off this inspection.

b. Unit in %

● If Expected component length = 1000um & Min Length Thres set

to 50%

● Fail when Measured Length < 1000um - [1000um*(50/100)]

c. Unit in um

● If Expected component length = 1000um & Min Length Thres set

to 100um

● Fail when Measured Length < 1000um - 100um

CR Type Algorithm - Body

3. Max Length Measure

a. Disable to off this inspection.

b. Unit in %

● If Expected component length = 1000um & Max Length Thres

set to 50%

● Fail when Measured Length > 1000um + [1000um*(50/100)]

c. Unit in um

● If Expected component length = 1000um & MAx Length Thres

set to 100um

● Fail when Measured Length > 1000um + 100um