Smart Gui - Algorithm Training Material_rev1.pdf - 第57页
Copyright © ViT rox All Rights Reserved . B-type Algorithm - Body 57 h. 3D Damaged Inspection ● T ick this to enable 3D Damaged Inspection i. Damaged Location ● T o adjust the location for the damages inspection boxes. ●…
Copyright © ViTrox All Rights Reserved.
B-type Algorithm - Body
56
g. Coplan Thres
● Vertical:
The measured height difference between the two coplanarity
inspection boxes in vertical direction.
● Horizontal:
The measured height difference between the two coplanarity
inspection boxes in horizontal direction.
3. Coplan Alternative
● Add another AND relationship coplan alternative which different
in the coplan location.
Both Primary and Alternative
must pass in order to pass
Coplan Thres (um)
Height Difference (um)
FAIL
PASS
Copyright © ViTrox All Rights Reserved.
B-type Algorithm - Body
57
h. 3D Damaged Inspection
● Tick this to enable 3D Damaged Inspection
i. Damaged Location
● To adjust the location for the damages inspection boxes.
● The smaller the percentage, The inner the boxes towards the centroid
j. Damaged Thres
● Software will check the height of these 4 boxes, the component will fail as
“Damaged” if the absolute height different between any one of the ROI's height
and component height higher than damaged threshold.
Damaged Thres (um)
Measured Height - Reference Height
FAIL
PASS
Copyright © ViTrox All Rights Reserved.
B-type Algorithm - Body
58
1. 3D Geometry Measure
● Tick this to enable the 3D Damaged inspection.
● Consists of minimum/maximum measure for length/width.
● Unit can be in % or um.
2. Min Length Measure
a. Disable to off this inspection.
b. Unit in %
● If Expected component length = 1000um & Min Length Thres set
to 50%
● Fail when Measured Length < 1000um - [1000um*(50/100)]
c. Unit in um
● If Expected component length = 1000um & Min Length Thres set
to 100um
● Fail when Measured Length < 1000um - 100um