00198661-02_UM_SX12-V3_EN.pdf - 第181页
Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 3 Technical data and assemblies From software version SC.713.1 Edition 12/2 020 3.11 Component tro lley 181 3.1 1.10 Empty t ape du ct on the component trolley COT ins…
3 Technical data and assemblies Instruction manual SIPLACE SX1/SX2 Edition V2 and V3
3.11 Component trolley From software version SC.713.1 Edition 12/2020
180
3.11.8.2 Maximum tape reel diameter in relation to the PCB conveyor height
3
3
3.11.9 Used tape chute
3
Fig. 3.11 - 9 Used tape chute for the component trolley COT insert
3
3
Without mount for the
additional tape reel
With mount for the
additional tape reel
PCB conveyor
height
of the component
trolley
Tape reel diameter Tape reel diameter
without spindle with spindle
900 mm 19" 17" 15"
930 mm 19" 19" 17"
950 mm 19" 19" 19"
PLEASE NOTE
Using spindles
SIPLACE SX1/SX2 component trolleys do not generally need spindles.
Use spindles if the error message "Timeout" appears frequently on the X feeder mod-
ule.
PLEASE NOTE
The used tape chute for the SIPLACE SX1/SX2 can only be installed on the component
trolley COT insert
for the SIPLACE SX1/SX2 (see fig. 5.15 - 4
, page 286).
Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 3 Technical data and assemblies
From software version SC.713.1 Edition 12/2020 3.11 Component trolley
181
3.11.10 Empty tape duct on the component trolley COT insert
In the standard version, the empty tape duct can guide component tapes with a maximum pocket
height of 12 mm to the pneumatic tape cutter.
3
Fig. 3.11 - 10 Empty tape duct on the SIPLACE SX1/SX2 component trolley COT insert
(1) Inlet slot for used tape
(2) Outlet slot for the used tape above the pneumatic tape cutter
(3) Dividing plate for tapes < 12 mm (can be removed for tapes > 12 mm)
3
PLEASE NOTE
Risk of blockages!
When using feeder modules with low pockets next to feeder modules with high pockets,
there is a risk of blockages in the empty tapes.
Do not position feeder modules with shallow pockets immediately beside feeder mod-
ules with deep pockets.
The separating plate (item 3 in fig. 3.11 - 10) can be removed for tape pockets higher than
12 mm (see section 4.5
, page 223).
(1)
(2)
(3)
3 Technical data and assemblies Instruction manual SIPLACE SX1/SX2 Edition V2 and V3
3.11 Component trolley From software version SC.713.1 Edition 12/2020
182