00198661-02_UM_SX12-V3_EN.pdf - 第284页
5 Tasks at the placement machine Instruction manual SIPLACE SX1/ SX2 Edition V2 and V3 5.15 Docking the component trolley in or out From software versi on SC.713.1 Edition 12/2020 284 5.15.2 Docking out the component tro…
Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 5 Tasks at the placement machine
From software version SC.713.1 Edition 12/2020 5.15 Docking the component trolley in or out
283
5.15 Docking the component trolley in or out
5.15.1 Safety instructions for docking component trolleys in and out
5
5
Fig. 5.15 - 1 Safety instructions for docking the component trolley in or out
In addition, the component trolley can only be docked in if the protective
covers are closed.
WARNING
DANGER OF CRUSHING!
Risk of crushing when docking and undocking the component trolley.
Always dock/undock the component trolley alone.
5 Tasks at the placement machine Instruction manual SIPLACE SX1/SX2 Edition V2 and V3
5.15 Docking the component trolley in or out From software version SC.713.1 Edition 12/2020
284
5.15.2 Docking out the component trolley
Go to the main view of the station software and select the Feeder module... icon and
then the
Locations icon.
5
Fig. 5.15 - 2 SC GUI - locations
5
Click on the icon to release the respective location and wait until the locking device
opens. For further information, refer to the station software Online Help.
Swivel the two handles up (item 1 in fig. 5.15 - 3).
Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 5 Tasks at the placement machine
From software version SC.713.1 Edition 12/2020 5.15 Docking the component trolley in or out
285
5
Fig. 5.15 - 3 Component trolley - swivel handles up to push
With both hands on the handles, pull the component trolley out of the placement machine.
5.15.3 Safety instructions for moving the component trolley
5
Always hold the handles with both hands when you want to move the component trolley.
Remember that a component trolley with the full complement of feeder modules can tip over
sideways or forward on gradients of 20° or more.
Make sure that the surface on which the trolley is moved has a significantly smaller gradient.
The floor underneath the placement machine may not exceed an incline of 0.63%. This cor-
responds to an incline of 5 mm over a distance of 800 mm (e.g. the width of a changeover
table).
Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast
enough.
WARNING
Avoid accidents!
To prevent accidents, ALWAYS follow the rules listed below when you move the compo-
nent trolley.