00198661-02_UM_SX12-V3_EN.pdf - 第66页

2 Operational safety Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 2.4 Safety instructions for trans porting the placement machine F rom software version SC.713.1 Edition 12/2020 66 2.4 Safety instructions for tra…

100%1 / 366
Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 2 Operational safety
From software version SC.713.1 Edition 12/2020 2.3 Classification of camera systems
65
2.3.2 Classification of the camera systems
2.3.2.1 Camera types with bright LEDs - risk group 1
The bright LEDs are fitted in the following cameras. These are classified as risk group 1, according
to IEC 62741:.
– Component camera types 30 and 45 for SIPLACE MultiStar (CPP)
– Component camera types 23 and 41 for SIPLACE SpeedStar (C&P20 P)
– Stationary camera types 25 and 33 for SIPLACE MultiStar (CPP) and SIPLACE TwinStar
– PCB camera, type 28
2
2.3.2.2 Camera types with blue LEDs - risk group 2
The ultra-bright blue LEDs are fitted in the following cameras. These are classified as risk group
2, according to IEC 62741:.
– Component camera type 48 for SIPLACE SpeedStar (C&P20 P2)
2
PLEASE NOTE
Risk group 1
Do not look into the beam of the ready-for-operation camera!
2
Risk group 2
The beam from cameras with
ultra-bright blue LEDs can be a haz-
ard.
Do not look into the beam of the ready-for-operation camera!
2 Operational safety Instruction manual SIPLACE SX1/SX2 Edition V2 and V3
2.4 Safety instructions for transporting the placement machine From software version SC.713.1 Edition 12/2020
66
2.4 Safety instructions for transporting the placement
machine
2
Use a fork-lift truck with the following specification to carry the placement machine:
Fork length: Min. 1800 mm
Carrying power: Min. 6,000 kg
Clear width between forks: Min. 350 mm
2
2
WARNING
Risk of tilting!
Risk of tilting, if the required specifications for the fork-lift truck are not observed.
Only use the specified fork-lift for transportation.
Correct transportation of the placement machine is described in chapter 4
, section 4.1,
page 183
.
Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 2 Operational safety
From software version SC.713.1 Edition 12/2020 2.5 Safety instructions for operating the SX1/SX2 placement machine
67
2.5 Safety instructions for operating the SX1/SX2 place-
ment machine
2.5.1 Safety instructions for closing the protective covers
To avoid risk of injury when closing the protective covers on the placement machine, the operator
must instruct the personnel concerned to always follow the instructions below when handling the
protective covers.
2
2
Fig. 2.5 - 1 Safety instructions for closing the protective covers
(1) Grab handles
To open or close the protective covers, always take hold of these by the grab handles.
When closing, do not reach into the gap between the protective cover and the machine panel.
When closing the protective cover, make sure that the area in which it is swiveled is free of
obstruction and that no other people are at risk of injury.
CAUTION
Risk of crushing hands!
Risk of crushing hands if the protective covers are not closed correctly.
Close the protective covers correctly.
(1)