00198661-02_UM_SX12-V3_EN.pdf - 第224页

4 Setting up and commissioning Instruction manual SIPLACE SX1/SX 2 Edition V2 and V3 4.6 Commissioning the placement m achine From software version SC .713.1 Edition 12/2020 224 4.6 Commissioning the placement machine 4.…

Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 4 Setting up and commissioning

From software version SC.713.1 Edition 12/2020 4.5 Adjusting the empty tape duct to the component height

223

4.5 Adjusting the empty tape duct to the component

height

If feeder modules which use tapes with a pocket height of > 12 mm are used, remove the sepa-

rating plate

(1).

(1) separating plate for tapes > 12 mm, removable

(2) Fastening screws

 Switch the placement machine off at the main switch to remove the dividing plate.

 Disconnect the placement machine from the power and compressed air supply.

 Lock the placement machine to prevent unauthorized reactivation, as described in section

2.9

, page 97.

 Vent the compressed air lines and the tape cutter:

 If there is a vent valve (only SIPLACE SX1/SX2 V3), open this valve.

 If there is no vent valve (SIPLACE SX1/SX2 V2 and older versions), pull off one of the

small hoses on the T-section of the tape cutter.

 Wait until the operating pressure for the tape cutter has dropped to 0 MPa.

 Loosen the fastening screws.

 Pull out the separating plate.

(1)

(2)

4 Setting up and commissioning Instruction manual SIPLACE SX1/SX2 Edition V2 and V3

4.6 Commissioning the placement machine From software version SC.713.1 Edition 12/2020

224

4.6 Commissioning the placement machine

4.6.1 Commissioning the placement machine at the customer's premises

 Check all modules for correct seating.

 Remove the shipping braces (see section 4.3.10, page 220).

 Wipe the linear guide rails of the X/Y axis with a lint-free cloth. Do not use any solvents (see

section 4.3.11

, page 220).

 Connect the power and compressed air supplies. Make sure that the incoming leads and ca-

bles can not be tripped over. If possible, run the incoming cables under the placement ma-

chine.

 Switch the placement machine on and check the function of the safety features such as the

EMERGENCY STOP button, position switch for covers and the component trolley.

 Perform a reference run.

 Perform initial calibration of the placement machine (see section 4.6.1.1, page 225).

 Load a recipe in the computer and test it.

 Check the placement machine zero point after a period of warming up of 3 - 4 h.

 Get the customer's operating personnel to equip the feeder modules according to the cus-

tomer's placement program.

 Instruct them in handling the feeder modules using the JobGuide.

Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 4 Setting up and commissioning

From software version SC.713.1 Edition 12/2020 4.6 Commissioning the placement machine

225

4.6.1.1 Performing initial calibration

 Click on "Service Tools" in the toolbar.

 Click on the Automatic calibration button.

Fig. 4.6 - 1 Service tools => automatic calibration

 Select Selection => Gantry axis calibration (1).

(1)