00198661-02_UM_SX12-V3_EN.pdf - 第279页

Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 5 Tasks at the placement machine From software version SC.713.1 Edition 12/2020 5.12 Changing the setu p 279 5.12 Changing the setup 5.12.1 Printing out the conversion…

5 Tasks at the placement machine Instruction manual SIPLACE SX1/SX2 Edition V2 and V3

5.11 Observing displays on the feeder module From software version SC.713.1 Edition 12/2020

278

5.11.2 Status display

–Green:

The feeder module is on standby and is contained in the current setup.

– Orange:

A warning is being signalized.

– Red:

A malfunction has occurred.

–Off:

The feeder module is not in the current setup.

PLEASE NOTE

"LED off" only for feeder modules contained in the setup

The placement machine controller switches off the status display of any feeder modules

not included in the setup.

The "LED off" status only occurs when the programming system has preset a job on the

line. This takes some of the work away from the operator since he only has to watch

those feeder modules that are contained in the setup.

PLEASE NOTE

Setup procedure: Activation of LED for each feeder module

For the actual setup process - no setup information at the station, no job sent from SI-

PLACE Pro to the station/line - the LED on each feeder module is activated after the set-

up has been made. The operator is thus informed whether everything is OK.

Instruction manual SIPLACE SX1/SX2 Edition V2 and V3 5 Tasks at the placement machine

From software version SC.713.1 Edition 12/2020 5.12 Changing the setup

279

5.12 Changing the setup

5.12.1 Printing out the conversion instructions before changing the setup

Before a change of setup, print out the conversion instructions on the printer for the SIPLACE Pro

computer as described in the "SIPLACE Pro" manual or in the online help.

5.12.2 What you should note when changing the feeder modules

 Handle the feeder modules carefully when you insert them into or remove them from the

changeover table. Make sure that the X feeder modules do not bump against the centering

bar (see item 5 in fig. 5.10 - 3

, page 270) of the changeover table.

 Vacuum the supporting surfaces of the feeder modules and clean the surface of the change-

over table when necessary according to the instructions in the preventive maintenance man-

ual.

 Remove loose components using a brush or a vacuum cleaner with a suitable nozzle.

CAUTION

Risk of injuries!

Fine metal splinters from components could injure hands.

 Avoid removing components from the changeover table with your fingers.

5 Tasks at the placement machine Instruction manual SIPLACE SX1/SX2 Edition V2 and V3

5.13 Avoiding track errors From software version SC.713.1 Edition 12/2020

280

5.13 Avoiding track errors

5.13.1 General

 Make sure that the areas around the feeder modules are clean and that there are no loose components

in the feeder area or under the feeder modules.

 Refill promptly with components.

 Splice the tapes early. This generally means that you are to prepare the splicing material when there

is still approximately 1.5 m of tape on the reel.

 Handle the feeder modules carefully when you insert them into or remove them from the changeover

table as these are high-precision devices.

 For X feeder modules, lower the pickup window since it can easily be damaged when raised.

 Check that the pick-up position is set correctly for the components on the feeder modules.

5.13.2 Avoiding track errors with the tape container

 Insert the separating plates correctly (see fig. 5.9 - 3, page 265).

PLEASE NOTE

A raised pick-up window leads to noticeably impaired pick-up quality.