2OM-1104-001.pdf - 第25页

1. Pattern Program 1.1 Model Name When a pattern program should be saved, up to 8 characters (alphanumerics and symbols) can be used as a pattern program name. 1.2 Operation Data 1.2.1 P .C.B. Data (1) P .C.B. Size X (ho…

100%1 / 387
Section 2
Pattern Program
0004-001 Chapter 1 2 1 AFU01EDTP
This section describes the contents and editing of the
pattern program.
1. Pattern Program
1.1 Model Name
When a pattern program should be saved, up to 8 characters (alphanumerics
and symbols) can be used as a pattern program name.
1.2 Operation Data
1.2.1 P.C.B. Data
(1) P.C.B. Size
X (horizontal), Y (vertical), and T (thickness)
Set the dimensions of the P.C.B. to be produced.
Unit: mm
Fig. 3B2
Data Input Range
X: 50
330 Y: 35 250 T: 0.5 5.0
(2) P.C.B. Origin OFfset
X (horizontal) and Y (vertical)
Set the offset values to correct the difference between the refer-
ence point (N
0
) of the pattern program and the P.C.B. origin (P
0
) .
Unit: mm
Fig. 3B4
Data Input Range
X: -99.999
+99.999 Y: -99.999 +99.999
X
Y
000.00
000.00
T
2.00
Fig.3B1
X
Y
+00.000
+00.000
Fig.3B3
P
0
(P.C.B. Origin)
Y +
X +
P.C.B.
N
0
(Printing Coordinates Reference)
1.1 Model Name
0004-001 Chapter 1 2 2 AFU01EDTP
(3) Operation Mode
It can be selected whether or not solder paste should be printed
on the P.C.B. to be produced.
PRINT: The machine prints solder paste during automatic opera-
tion.
PASS : The machine pereforms only P.C.B. transfer during auto-
matic operation.
(4) Print Area
Set parameters as offset values of the P.C.B. end plane in the Y
direction.
Unit: mm
Enter the offset values based on the pattern program coodinates
of the end planes on the origin and rear sides. When the defaults
"0" (zero) are set, the whole area of the P.C.B. is printed.
Various offsets are considered in the actual printing range as shown
below.
L1, L2 : Printing Area Data (based on the pattern program origin)
X2 : Overshoot at End of Printing
S
o : Travel from Previous End Position at Printing Start (Squee-
gee Offset)
Fig.3B7
Data Input Range
Origin Side : -10 +250
Rear Side : -250
+10
Origin
Depth
+ 000.00
+ 000.00
Fig.3B6
1.2 Operation Data
0004-001 Chapter 1 2 3 AFU01EDTP
Operation Mode Print
Fig.3B5
Screen Center
S
o
S
o
Squeegee
L1
X2
(-)
P.C.B.
Pattern
Program
Origin
L1
X2
(+)