2OM-1104-001.pdf - 第254页
Fig. 5A22 R Conveyor Section Spline Shaft for Width Adjustment Clean the shaft with an oiled rag. Note: Remove waste thread if any . Cleaning Ball Screw for Width Adjustment Clean the screw with an oiled rag. Note: Remov…
Spline Shaft for Width
Adjustment
Clean the shaft with an oiled
rag.
Note: Remove waste thread
if any.
Cleaning
Ball Screw for Width
Adjustment
Clean the screw with an oiled
rag.
Note: Remove waste thread
if any.
Cleaning
Guide Bushing for Width
Adjustment
Clean the bushing with an
oiled rag.
Note: Remove waste thread
if any.
Cleaning
0004-001 Chapter 3 1 18 AFU01EINP
6. Monthly Maintenance
Fig. 5A21 L Conveyor Section
Fig. 5A22 R Conveyor Section
Spline Shaft for Width
Adjustment
Clean the shaft with an oiled
rag.
Note: Remove waste thread
if any.
Cleaning
Ball Screw for Width
Adjustment
Clean the screw with an oiled
rag.
Note: Remove waste thread
if any.
Cleaning
Guide Bushing for Width
Adjustment
Clean the bushing with an
oiled rag.
Note: Remove waste thread
if any.
Cleaning
0009-002 Chapter 3 1 19 AFU01EINP
6. Monthly Maintenance
7. Maintenance (Every 3 Months after Initial Month)
NM1: NEW MOLYNOC GREASE No. 1
Table 5A7
Maintenance Spots
Description
Grease
Cleaning
Check
Tools,
Name
DWG
Nozzles,
No. etc.
Table
Outer Circumference
5A22 Lubrication NM1 Brush and
Section of
-Axis Movable -1 Spatula
Bearing
Fig. 5A22-1 Table Section
0106-002 Chapter 3 1 19-1 AFU01EINP
Outer Circumference of -
Axis Movable Bearing
Lubrication
Apply grease with a brush or
a spatula.
7. Maintenance (Every 3 Months after Initial Month)