2OM-1104-001.pdf - 第260页

Backup T able Z-Axis Guide Bushing (1) Move up the backup table Z axis. (2) Apply grease with a brush or a spatula. Lubrication Ball Screw for Chute Width Adjustment (1) Move up the backup table Z axis. (2) Apply grease …

100%1 / 387
-Axis Ball Screw
Apply grease with a brush or
a spatula.
Lubrication
-Axis Linear Guide
Apply grease to the grease
nipple with a grease gun.
Lubrication
Fig. 5A24 Table Section
Fig. 5A25 Table Section
8. Half-Yearly Maintenance
0106-003 Chapter 3 1 23 AFU01EINP
Z-Axis Ball Screw
(1) Move the table Z axis up
to the printing position.
(2) Detach the cover located
at the front side of the table.
(3) Apply grease with a brush
or a spatula.
Lubrication
Z-Axis Guide Bushing
(1) Move the table Z axis up
to the printing position.
(2) Detach the cover located
at the front side of the table.
(3) Apply grease with a brush
or a spatula.
Lubrication
Backup Table Z-Axis Guide
Bushing
(1) Move up the backup table
Z axis.
(2) Apply grease with a brush
or a spatula.
Lubrication
Ball Screw for Chute Width
Adjustment
(1) Move up the backup table
Z axis.
(2) Apply grease with a brush
or a spatula.
Lubrication
Linear Guide for Chute Width
Adjustment
(1) Move up the backup table
Z axis.
(2) Apply grease with a brush
or a spatula.
Lubrication
Backup Table Z-Axis Ball
Screw
(1) Move up the backup table
Z axis.
(2) Apply grease with a brush
or a spatula.
Lubrication
Fig. 5A26 Chuck Section
8. Half-Yearly Maintenance
0009-002 Chapter 3 1 24 AFU01EINP
8. Half-Yearly Maintenance
Linear Guide for P.C.B.
Clamping
Lubrication
Apply grease with a brush or
a spatula.
0009-002 Chapter 3 1 25 AFUQ01EINP
X-Axis Linear Guide
Apply grease with a brush or
a spatula.
Lubrication
P.C.B. Stopper Guide Bushing
Apply grease with a brush.
Note: If a large amount of
grease is applied to the
ball screw, it may be
dispersed over a P.C.B.
and the screen. After
applying grease to the
ball screw, brush the
surface or scrape with a
spatula until a small
amount of grease
remains.
Lubrication
Fig. 5A27 Chuck Section
Fig. 5A28 P.E.C. Recognition Section