CAN Bus Workshop_Version 03__06-2008_EN.pdf - 第220页

1 - 12 Siplace C AN T est Box 1 CAN T est Box Edition 04/200 8 12 Fig. 1.8 - 1 CAN telegram with error frame The Error Frame Count er switch es, since one block of the CA N telegr am (6 bits in this case) has maintained …

1 - 11

Siplace CAN Test Box

Edition 04/2008 1 CAN Test Box

1.8 Checking the CAN Bus for Error Frames

What are error frames?

Error frames are sent by the individual subsystems, when a command does not adhere to the en-

coding rules or has been physically corrupted.

This occurs when a CAN telegram shows the same RxD level (low) for 6 or more consecutive bits

(logic 0 = dominant).

If a subsystem recognizes this type of command, it will immediately notify all other subsystems

and the transmitter of the telegram, by sending error frames.

After receiving an error frame, the other subsystems will reject the message (telegram) sent and

send their own error frames. Once the bus is free again, the command will be resent.

The CAN Test Box is used to check the CAN network for error frames.

Note: When switching the machine on and off, the CAN Test Box will recognize any error frames.

This means that the Error Frame Counter have to reset after each reboot manually.

Step by step: 1

➠ Connect the CAN Test Box to the service plug (Note: Not all signals on the Service plug) of the

COM assembly.

➠ Switch the machine on and start the placement program.

➠ During production, the CAN Test Box can remain connected, even with the oscilloscope. The

trigger input should be connected to the BNC socket error frame of the CAN Test Box.

➠ The number of error frames can be seen on the counter. An accumulation of error frames in-

dicates possible physical bus errors.

If too many error frames are recognized during operation, you will need to analyze the CAN

signals in detail.

Guideline value: Number of error frames during 4h placement operation < 10

1 - 12

Siplace CAN Test Box

1 CAN Test Box Edition 04/2008

Fig. 1.8 - 1 CAN telegram with error frame

The Error Frame Counter switches, since one block of the CAN telegram (6 bits in this case) has

maintained the same state for approx.6μs. For a 1MBit bus, 1 bit has a length of 1μs, resulting in

a max. block length at the same level of 5μs.

The CAN Test Box Error Frame Counter is preset and counts 1 Mbit CAN bus at 5.5μs. 500KBaud

CAN bus HS60 is counted at 11μs.

These settings of 5.5μs and 11μs are factory set in the CAN Test Box with the help of a potenti-

ometer.

5.9μs

CAN _H level

CAN _L level

1 - 13

Siplace CAN Test Box

Edition 04/2008 1 CAN Test Box

Comments: