FlexTRAK OH Material Handler Manual.pdf - 第153页

FlexTRAK-OH Material Handli ng System IOM Manual Material Handler Oper ation © 2023 Nordson C orporation 4-65 4. Prepare a m agazine load ed with untr eated strips.  Before loading magazi ne into manual loading p ort , …

100%1 / 272
FlexTRAK-OH Material Handling System IOM Manual Material Handler Operation
4-64 © 2023 Nordson Corporation
4.16 Manual Magazine Loading and Unloading
4.16.1 Magazine Loading
1. Manually check the magazine replenish status through the HMI screen.
2. If the magazine is depleted, open the magazine loading cover (A1) (Figure 4-104).
3. Lift up the access cover until the latch is locked on the cover.
Item Description
A1 Magazine with untreated strips loading port.
B1 Magazine with treated strips unloading port.
Figure 4-104 Magazine Loading and Unloading Ports
FlexTRAK-OH Material Handling System IOM Manual Material Handler Operation
© 2023 Nordson Corporation 4-65
4. Prepare a magazine loaded with untreated strips.
Before loading magazine into manual loading port, ensure the magazine barcode (2)
and the loading direction (1) are displayed on the magazine top surface (Figure 4-105).
5. Press down both the strip feed in stopper latch (3) and the strip out stopper latch (4) to close
the magazine stopper bar.
Figure 4-105 shows the open position and close position of the stopper latch.
Item
Description
1
Magazine Loading Direction
2
Magazine Barcode
3
Strip Feed In Stopper Latch
4
Strip Out Stopper Latch
Figure 4-105 Preparing the Magazine
6. Hold the magazine and walk to the manual loading port area (Figure 4-106).
Do not touch the strips with bare hands. Use authorized hand gloves permitted by the
manufacturing plants.
Figure 4-106 Loading the Magazine 1
FlexTRAK-OH Material Handling System IOM Manual Material Handler Operation
4-66 © 2023 Nordson Corporation
7. Tilt the magazine to align all untreated strips with the magazine edge at the rear side
(Figure 4-107).
Figure 4-107 Loading the Magazine 2
8. Manually place the magazine into manual loading port (Figure 4-108).
Figure 4-108 Loading the Magazine 3
9. Open the latches (Figure 4-109).
10. Softly push the magazine towards the guide bar until it is transferring to the rear and side
position.
Figure 4-109 Loading the Magazine 4
11. Press the START button on pilot switch (Figure 2-9) to run the machine production mode.
12. Repeat Step 2 through Step 10 to load additional magazines.