FlexTRAK OH Material Handler Manual.pdf - 第160页

FlexTRAK-OH Material Handli ng System IOM Manual Material Handler Operation 4-72 © 2023 Nordson C orporation 5. Select the vision system and cli ck OK to proceed to the next step ( Figure 4- 118 ) . Figure 4- 118 Visions…

100%1 / 272
FlexTRAK-OH Material Handling System IOM Manual Material Handler Operation
© 2023 Nordson Corporation 4-71
c. Enter the tag ID obtained from Table 4-6 into Recipe# screen
Where:
74 = strip size
006 = lane quantity
01 to 05 = RFID location labeling in strip lane kit module
Note: Tag ID will be varied when the strip size and lane quantity used is different.
5. Hold the dedicated RFID tag parts close to the RFID device.
6. Press WRITE to execute the RFID device writing process, and press READ to execute the
RFID device reading process (Figure 4-116).
Ensure the Tag Write and Tag Read fields show the correct tag ID as declared or
written.
7. Insert the RFID parts into the designated location in the RFID holding fixture.
8. Repeat Step 4 through Step 7 until all RFID parts are completely written and read.
9. When all settings are done, press HOME on bottom left corner to return into home screen.
4.18 Barcode/2D Reader Setup
4.18.1 Magazine
Refer 3.7.3 Magazine Scanner Installation and/or Adjustment (Optional Feature) for similar descriptions.
4.18.2 Strip
The Strip ID as shown in Figure 1-14 is readable with strip ID reader Refer to 1.5.3 Strip Loading Buffer
(Stn20).
To configure the software for the Strip ID reader:
1. Connect the laptop to the machine via LAN cable.
2. Close "Microscan AutoVision software".
3. Open "Visionscape" software.
4. On top right corner of the Visionscape FrontRunner window, click
Add Btn to add the
camera device.
FlexTRAK-OH Material Handling System IOM Manual Material Handler Operation
4-72 © 2023 Nordson Corporation
5. Select the vision system and click OK to proceed to the next step (Figure 4-118).
Figure 4-118 Visionscape FrontRunner – Select Vision System
6. Select the camera according to the IP address (Figure 4-119).
• 192.168.19.3 – Loader strip scanner
• 192.168.19.4 – Unloader strip scanner
Figure 4-119 Select Camera According to IP Address
7. When the camera selection field turns yellow, select Stop Running Camera (Figure 4-120).
Figure 4-120 Select Stop Running Camera
FlexTRAK-OH Material Handling System IOM Manual Material Handler Operation
© 2023 Nordson Corporation 4-73
You will receive the following prompt (Figure 4-121).
Figure 4-121 Device State Changed
8. Click Yes to upload program for editing.
9. Select
Editor from the top right corner of the editing window (Figure 4-122) to open a
window where you can fine-tune the settings (Figure 4-123).
Figure 4-122 FrontRunner Editing Window