FlexTRAK OH Material Handler Manual.pdf - 第87页

FlexTRAK-OH Material Handli ng System IOM Manual Installation © 2023 Nordson C orporation 3-37 Figure 3- 62 Unloader Kic ker Sensitivity Adjustm ent 3  NOTE Specification values are with in the range of 8 0 to 200 grams…

FlexTRAK-OH Material Handling System IOM Manual Installation

3.7.10 Unloader Kicker Sensitivity Adjustment

1. Prepare a tension gauge (Figure 3-60).

a. Ensure the tension gauge is in good condition.

b. Reset both needles to the default position by rotating the knob in the clockwise or

counterclockwise direction.

Figure 3-60 Unloader Kicker Sensitivity Adjustment 1

2. Put the gauge needle on the unloader kicker then pull it in the direction as indicated by the

red arrow (Figure 3-61).

Figure 3-61 Unloader Kicker Sensitivity Adjustment 2

3. Return the unloader kicker into original position then notice the reading directly from the

gauge (readings shown by red needle).

4. If the tension gauge does not show a proper reading, use a screw driver to loosen or tighten

the screw nut until correct reading is obtained.

FlexTRAK-OH Material Handling System IOM Manual Installation

Figure 3-62 Unloader Kicker Sensitivity Adjustment 3

 NOTE Specification values are within the range of 80 to 200 grams. Actual settings used should

correspond to maximum allowable force to push the strip out of unloader station. Refer to

Table 3-13 for sample readings.

Table 3-13 Unloader Kicker Sensitivity Sample Readings

Items I/O

Threshold

force (gram)

Actual force

(gram)

Unloader kicker I012.01 110 180