FlexTRAK OH Material Handler Manual.pdf - 第65页
FlexTRAK-OH Material Handli ng System IOM Manual Installation © 2023 Nordson C orporation 3-15 9. Safely plug in cla w 1 circular c onnector (A) and claw 2 circular con nector (B) into the machine ( Figure 3- 27 ) . 10. …
FlexTRAK-OH Material Handling System IOM Manual Installation
3-14 © 2023 Nordson Corporation
f. Repeat Step d and e to install strip claw 2 assembly onto the strip transfer claw module
– claw 2 linkage (Figure 3-25 and Figure 3-26).
Figure 3-25 Position of Claw 1 (A1) and Claw 2 (A2) Linkage on the Strip Transfer Claw Module
Figure 3-26 Installation of Strip Claw 2
8. When all the above settings are completed, perform final integration checking on the
conversion kit. Ensure all parts are tightened properly.
FlexTRAK-OH Material Handling System IOM Manual Installation
© 2023 Nordson Corporation 3-15
9. Safely plug in claw 1 circular connector (A) and claw 2 circular connector (B) into the
machine (Figure 3-27).
10. Ensure there is no damage at all claw 1 and claw 2 sensor cables, vacuum tube fittings, and
vacuum air manifold feeding.
Figure 3-27 Plug In Circular Connectors
11. Close the front sliding door (Figure 3-28).
12. Press RESET on the pilot switch (Figure 2-9) to acknowledge and clear the current alarm
indicating the front sliding door is open.
Figure 3-28 Close Front Sliding Doors
FlexTRAK-OH Material Handling System IOM Manual Installation
3-16 © 2023 Nordson Corporation
3.7.2 Magazine Scale Plate Adjustment
The magazine clamper holder plate (A) provides a magazine gripper (B) center position against the
clamped magazine and is located in strip loading buffer area and strip unloading buffer area
(Figure 3-29).
Figure 3-29 Magazine Scale Plate Adjustment
To adjust the magazine clamper holder plate:
1. Open the left and right sliding doors to access into the machine interior components from
side view (Figure 3-30).
Figure 3-30 Open Side Sliding Doors
WARNING! Ensure machine is in idle mode by observing the light tower status lights (solid
yellow). Ensure all workpieces (magazine and strip) are removed from the
machine.