FlexTRAK OH Material Handler Manual.pdf - 第178页
在线预览 FlexTRAK OH Material Handler Manual.pdf PDF 文档。
FlexTRAK-OH Material Handling System IOM Manual Maintenance
© 2023 Nordson Corporation 5-13
5.11 Magazine Gripper Replacement
To replace the magazine gripper (Figure 5-11):
1. Loosen four (4) screws (A) to separate the magazine side plate (B) from the cylinder (C).
2. Loosen four (4) screws (D) to separate the magazine side plate (B) from the cylinder holder
plate (E).
3. Remove side plate from the module.
4. Reverse Step 1 through Step 3 above for gripper side plate replacement.
5. For the gripper holder module, loosen two (2) screws (F) to separate the plate holder (G)
from the top mounting plate (H).
6. Remove the gripper holder from the module.
7. Reverse Step 5 and Step 6 above for gripper holder replacement.
Figure 5-11 Magazine Gripper Replacement
© 2023 Nordson Corporation 6-1
6 Troubleshooting
6.1 Overview
This section describes typical FlexTRAK-OH process alarm conditions that can occur during system
operation and provides troubleshooting tips for their correction.
This section contains the following topics:
• Alarm and Recovery
6.2 Safety First
Operation of your FlexTRAK-OH Material Handler involves mechanical devices, air pressure, and
electrical power. It is essential that every person servicing or operating the FlexTRAK-OH fully
understands all hazards, risks, and safety precautions. When properly operated and maintained, the
FlexTRAK-OH Material Handler should be safe and reliable. Refer to Section 2 - Safety prior to
troubleshooting
.