FlexTRAK OH Material Handler Manual.pdf - 第171页
FlexTRAK-OH Material Handli ng System IOM Manual Maintenance © 2023 Nordson C orporation 5-7 5.9.2 Loader El evator Pit ch Wheel Sensor (C YL 2002) Cylinder 200 2 is mounted with the sensor (strip sensor s ) pl ate in St…
FlexTRAK-OH Material Handling System IOM Manual Maintenance
5-6 © 2023 Nordson Corporation
5.9 Common Cylinder Replacement
5.9.1 Loader and Unloader Elevator Gripper (CYL 2001 and 4001)
To remove and replace the loader and unloader elevator gripper cylinder (Figure 5-2):
1. Loosen two (2) screws (A) to separate the mounting plate (B) with the cylinder (C).
2. Loosen four (4) screws (D) to separate the magazine side plate (E) with the cylinder holder
plate (F).
3. Safely remove the cylinder from the module.
4. Reverse the steps above to install a new cylinder into the module.
Before installing the new cylinder, ensure the sensor position is properly measured and
marked (Figure 5-3).
Figure 5-2 Loader and Unloader Elevator Gripper (CYL 2001 and 4001)
Figure 5-3 Measure Sensor Position
FlexTRAK-OH Material Handling System IOM Manual Maintenance
© 2023 Nordson Corporation 5-7
5.9.2 Loader Elevator Pitch Wheel Sensor (CYL 2002)
Cylinder 2002 is mounted with the sensor (strip sensors) plate in Station 20. The following steps explain
on how to remove and replace the cylinder:
To remove and replace the loader elevator pinch wheel cylinder (Figure 5-4):
1. Loosen four (4) screws (A) to separate the sensor plate (B) with the cylinder top plate (C).
2. Remove the sensor plate.
3. Loosen four (4) screws (D) to separate the cylinder with the spacer (E) that is mounting on
the cylinder plate.
4. Remove the cylinder.
5. Reverse the steps above to install a new cylinder into the module.
Figure 5-4 Loader Elevator Pitch Wheel Sensor (CYL 2002)
FlexTRAK-OH Material Handling System IOM Manual Maintenance
5-8 © 2023 Nordson Corporation
5.9.3 Loader Elevator Kicker (CYL 2003)
To remove and replace the loader elevator kicker cylinder (Figure 5-5):
1. Loosen two (2) screws (A) to separate cylinder 2003 with the adjustment mounting plate (B).
2. Remove the cylinder.
3. Reverse the steps above to install a new cylinder into the module.
Figure 5-5 Loader Elevator Kicker Cylinder