FlexTRAK OH Material Handler Manual.pdf - 第78页
FlexTRAK-OH Material Handli ng System IOM Manual Installation 3-28 © 2023 Nordson C orporation 3.7.7 Pinch Wh eel Setup 3.7.7.1 Pinch Wheel End Block I nstallation and/ or Removal The p inch wheel end bl ock ( Figure 3- …
FlexTRAK-OH Material Handling System IOM Manual Installation
© 2023 Nordson Corporation 3-27
3.7.6.2 Fine-tuning the Amplifier
1. Press and hold L/D for 3 to 5 seconds until the red light is on (Figure 3-46).
2. Press
UP or DOWN to increase or decrease the threshold limit, until the correct threshold
limit is displayed on the screen.
Figure 3-46 Fine-tuning the Amplifier
3.7.6.3 Setting the Amplifier Threshold Limit
The threshold limit decreases (zero or lower value) when the magazine contains a strip and increases
(higher value) when there is no strip in the magazine. Table 3-9 and Table 3-10 show sample readings
obtained in these two modes.
Table 3-9 Without Strip Result
Sensor IO
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
I005.02 110 140 130 84 90 170
Table 3-10 With Strip Result
Sensor IO
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
I005.02 0 0 0 2 0 0
Threshold limit set in amplifier =
(lowest value without strip + highest value with strip)
2
=
(84+2)
2
= 43
Perform Step 2 in 3.7.6.2 Fine-tuning the Amplifier and press the UP or DOWN button to adjust the
threshold limit until "43" is displayed on the screen.
FlexTRAK-OH Material Handling System IOM Manual Installation
3-28 © 2023 Nordson Corporation
3.7.7 Pinch Wheel Setup
3.7.7.1 Pinch Wheel End Block Installation and/or Removal
The pinch wheel end block (Figure 3-47) must be installed at end of the rail (machine front side) for both
input and output buffer lanes. The purpose is to guide the position of the pinch wheel on the LM (linear
motion) rail between first lane and last lane.
Figure 3-47 Pinch Wheel End Block
To install the pinch wheel end block on LM rail:
1. Remove circlip (A).
2. Loosen all screws (B) and remove the shaft stopper block (C) from pinch wheel plate (D).
3. Insert the pinch wheel end block (E) into LM guide rail (F).
Figure 3-48 Installing the Pinch Wheel
FlexTRAK-OH Material Handling System IOM Manual Installation
© 2023 Nordson Corporation 3-29
NOTE Do not remove the bearing stopper (G) to prevent the bearing from dropping out
(Figure 3-49).
Figure 3-49 Bearing Stopper
4. Place the end block vertically (end block at the bottom surface (Figure 3-50).
5. Slide in LM guide (H) carefully and remove the bearing stopper (G).
Figure 3-50 Inserting the LM Guide
6. Install shaft stopper block (C) and tighten all screws (B) to assemble with the pinch wheel
plate (D).
7. Install circlip (A).
8. To remove pinch wheel end block from the LM guide rail, reverse all the steps above.
This setting is applicable for both input and output buffer lanes.