1OM-1064-002.pdf - 第139页
5. Preparation and Confirmation before Operation Beam A Side Beam B Side (Front Side of Machine) Fig. 2.25-1 Nozzle Stocker Position Fig. 2.25-2 Rough View of Nozzle Stocker Fig. 2.25-3 Direction of Nozzle Arrangement No…
5. Preparation and Confirmation before Operation
0103-002 2-40 Tg0246-PM-OP
Fig. 2.24-4
Notes: (a) When some components are previously placed on the back of the
P.C.B. and P.C.B. support pins are inserted, make sure that no pin
touches a component.
(b) P.C.B. support pins cannot be inserted into the holes on the backup
table which are located closest to the clamp plate on the fixed
side.
(c) When a component is trapped or dust has accumulated on the
backup table, the height of the P.C.B. support pins cannot be set
correctly. In this case, remove the component or dust with a vacuum
cleaner, etc. (Air Blowing Prohibited)
(d) When the P.C.B. support pins are inserted near the clamp plate on
the movable side, the distance between the center of the holes on
the backup table and the clamp base must be 5.5 mm or more.
5. Preparation and Confirmation before Operation
Beam A Side
Beam B Side
(Front Side of Machine)
Fig. 2.25-1 Nozzle Stocker Position Fig. 2.25-2 Rough View of Nozzle Stocker
Fig. 2.25-3 Direction of Nozzle Arrangement
Nozzle
Storage Section
Nozzle Stocker B
Nozzle Stocker A
Set the nozzle in the nozzle
stocker, taking care of the
direction of the nozzle.
Imprinted Nozzle ID
Nozzle Stocker A
Nozzle
Imprinted Nozzle ID
Nozzle Stocker
B
Beam B Side
(Front Side of Machine)
5.2.3 Preparation of Nozzle Stocker Section
Set the nozzles (the nozzles to be used in the current program) in the nozzle
storage section of the nozzle stocker.
The nozzles must be set as shown in Fig. 2.25-3.
Direct the imprinted nozzle ID mark as shown in the figure and insert the
nozzle into the groove.
Magnified
View
9910-001 2-41 Tg0246-PM-OP
5. Preparation and Confirmation before Operation
5.2.4 Preparation of Feeders
Note: Use the feeders especially prepared for TIM-5000 series.
The feeders for another machine cannot be used.
Tape Feeders
• Check which type of tape feeder should be installed in which slot No. (FDR
NO.).
• Install tape feeders correctly such that they are seated securely. Otherwise,
errors such as a pick-up error will occur.
Refer to “1.6 Installation and Removal of Tape Feeders on/from Feeder Base”
in the instruction manual of the tape feeders for details.
Vibratory Stick Feeders
Refer to the instruction manual of the vibratory stick feeders.
Multi-Layer Tray Feeders (Option)
Refer to the instruction manual of the multi-layer tray feeders.
9910-001 2-42 Tg0246-PM-OP