1OM-1064-002.pdf - 第216页
7. T ray Pick-Up Matrix (Option) • Case: The machine is in the “STOP” or the “P AUSE” mode. Shown are the matrix positions of the tray components to be picked up sub- sequently . (Fig. 3.26) The matrix can be changed whi…
7. Tray Pick-Up Matrix (Option)
0103-001 3-45 Tg0246-PM-OP
*3 [INIT.]
This key initializes tray pick-up matrix data for the step to be initialized.
After initialization, the selection of switches in the column for the step to
be initialized and the selection of the [MATRIX INIT.] are cancelled.
Note: Only the data for the blocks used in the current program, can be
initialized.
The data where the feeder No. is not set or the feeder No. is set
but not used in the current program, is not initialized.
7. Tray Pick-Up Matrix (Option)
• Case: The machine is in the “STOP” or the “PAUSE” mode.
Shown are the matrix positions of the tray components to be picked up sub-
sequently. (Fig. 3.26)
The matrix can be changed while the machine is in the “STOP” or the
“PAUSE” mode.
9910-001 3-46 Tg0246-PM-OP
Fig. 3.26
To change the matrix, press the [ ] or the [ ] key to select the related block.
Select the [X] or the [Y] key, use the ten-key pad to specify the matrix posi-
tion, and press the [SET] key to define the parameters.
After the matrix position is defined, press the [RTN] key.
The “DATA SAVE MODE” display (Fig. 3.27) appears on the screen. To save
the changed matrix position, press the [SAVE] key. Otherwise, press the [DON’T
SAVE] key.
Fig. 3.27
Section 4
Manual Mode Menus
9910-001 4-1 Tg0246-PM-OP