1OM-1064-002.pdf - 第210页

6. RECOVERY OPN. TEACHING OPN. Display  9910-001 3-41 Tg0246-PM-OP 6.4 FEEDER (B) OFFSET Display When the [FEEDER (B) OFFSET] key is pressed at the “RECOVER Y OPN. TEACHING OPN.” display , the following display appears …

6. RECOVERY OPN. TEACHING OPN. Display

Fig. 3.21

(4) Select the [SAVE] or the [DON’T SAVE] key.

When the [SAVE] key is pressed, the changed component carriage data is

saved and the “COMPONENT CARRIAGE DATA EDIT” display (Fig.

3.19) appears on the screen.

When the [DON’T SAVE] key is pressed, the changed component car-

riage data is not saved.

Notes: (a) Parameters can be changed only when the control command “-”

or “E” is set with the machine in the “STOP” or the “PAUSE”

mode.

(b) The component carriage parameters (packaging change data) are

updated (cleared) after a program change operation is performed.

When the feeder Nos. match the slot Nos. of the actually allo-

cated feeders perfectly before and after the program change op-

eration is performed, the component carriage parameters are

backed up (succeeded).

9910-001 3-40 Tg0246-PM-OP

6. RECOVERY OPN. TEACHING OPN. Display



9910-001 3-41 Tg0246-PM-OP

6.4 FEEDER (B) OFFSET Display

When the [FEEDER (B) OFFSET] key is pressed at the “RECOVERY OPN.

TEACHING OPN.” display, the following display appears on the screen.

Note: The -marked item is optional.

Fig. 3.22

The feeder (B) offset data is used to correct the positional deviation in compo-

nent pick-up positions caused due to the variation in feeders.

Refer to “5.2.5 FEEDER (B) OFFSET Display of Section 2” for details.

7. Tray Pick-Up Matrix (Option)

When the [TRAY PICK-UP MATRIX] key is pressed at the “AUTO OPN

SUB-MENU” display, the following display appears on the screen. (Hierar-

chical Sequence: “AUTO OPN MODE (PLACEMENT)” Display →

“AUTO

OPN SUB-MENU” Display)

0103-003 3-42 Tg0246-PM-OP

Fig. 3.23

Press the [TRAY L] or the [TRAY R] key to select the multi-tray feeder L or R.

When the [TRAY L] or the [TRAY R] key is pressed, the following display or

the similar one appears on the screen.

(In this example, the “TRAY [L] LWR MAG PICK-UP MAT” display is shown.

The display for “Tray R” looks like this.)

Fig. 3.24

[STEPS] Keys

When one of the [STEPS] keys is pressed, the step of the upper or the

lower magazine corresponding to the key is selected.

The numbers represent the step Nos. (including the step offset).

The numbers in ( ) represent the actual step Nos.