Administrator’s Guide(CP45FV) Eng.pdf - 第180页
Samsung Component Placer CP45FV Series Administrator ’ s Guide Figur e 1 1-3. “ Pr oduction ” Main scr een (Initial scr een ) When the submenu, PCB D/L (F7) is clicked on, transmits the PCB data edited to the machine, an…
Production Setup
Chapter 11. Production Setup
11-1
The production menu is composed of nine submenus; Start, Stop, Cont., Finish, T/F Cnt,
PCB D/L, Plc. Info, Sts. Info and Feeder Monitor.
This menu performs the function of monitoring PCB (Printed Circuit Board) placement
operation..
Figure 11-1. When the Production command is selected
Figure 11-2. Submenus of the Production command(Initial status)
11.1. Production Main
When the production button is clicked on, the following screen is displayed.
Samsung Component Placer CP45FV Series Administrator’s Guide
Figure 11-3. “Production” Main screen (Initial screen)
When the submenu, PCB D/L (F7) is clicked on, transmits the PCB data edited to the
machine, and the following screen is displayed.
<Board Description > group
Displays the data related to PCB board.
11-2
Production Setup
11-3
<Customer> Static box
Displays the customer name.
<Board Name> Static box
Displays the PCB name.
<Total Steps> option button
Displays the total number of steps.
<Total Cycles> option button
Displays the total number of cycles.
<Total Array> option button
<Working Status> group
Displays the status of operation in progress.
<Place Progress> Static box
Displays the progress of placement operation with a percentage and a progress
bar.
<Current Cycle> Static box
Displays the cycle in progress.
<Current Array> Static box
Displays the step in progress.
<Produced PCBs> Static box
Displays the number of produced PCBs.
<Reset> button
Initializes the number of produced PCBs to “0”.
<Speed> group
Set the speed of axis.
<Execution Mode> group
Set the execution mode.
<Step> option button
Sets to a mode in which the motion stops after each step of motion.
<Continuous> option button
Sets to a mode of continuous motion.
<Operation Mode> group
Set the operation mode. Available modes are as follows.
Normal Run: Operates normally.
Dry Run: Operates without picking up components actually. When all the steps are
completed, stops operation.
Dry Repeat Run: Operates without picking up components actually. When all the
steps are completed, repeats operation from the first.
Dry1 Run:
Dry1 Repeat Run:
Dry2 Run:
Dry2 Repeat Run: