Administrator’s Guide(CP45FV) Eng.pdf - 第204页

Samsung Component Placer CP45FV Administrator ’ s Guide T each the center of the component to be placed.  If possible, obtain the correct center point using the 2 point teaching m ethod for accurate teaching. T each the…

Teaching

13-7

The position of the fiducial mark displayed on the above screen is the position of the

mark obtained through the scan test. If you want to update the value, click on “Yes,” if

not click on “No”. This is performed to correct the position of the mark already

entered accurately using the registered mark data. Perform more than twice for

application.

13.2. Point Teaching

13.2.1. Placement Point Teaching

This is to teach the position (center of the component) on the PCB, where the component

is to be placed. The teaching is done manually or by importing the CAD data.









Manual teaching procedure

Load the PCB to teach on the working area of the conveyor.

Enter the size of the PCB and click the <Conv.Width> button to adjust the

conveyor width to the PCB.

Feed the PCB on the convey inlet and click the <PCB In> button.

Fix the PCB and set the placement origin.

Select the fiducial camera as a teaching device and teach the position of the edge

of the component nearest to the stopper among the components to be mounted on

the PCB.

(Stopper Position Teaching) (Component Edge Position Teaching on the PCB)

Samsung Component Placer CP45FV Administrator’s Guide

Teach the center of the component to be placed. 

If possible, obtain the correct center point using the 2 point teaching method for

accurate teaching.

Teach the positions of two points on the edges facing diagonally to obtain the

center point.



Once the teaching of the two points is completed, the center of the

component is obtained automatically. Enter the coordinate as the center of

the component.

In the above dialog box, the constant value was entered as the Z value. This

allows the bottom surface of the component to be placed below the top surface of

the PCB. Sometimes the value of -0.3 ~ -0.5mm is entered in the dialog box for

accurate placement considering the PCB warping.

Placement point teaching procedure using CAD data 

13-8

Teaching

13-9

 Click the <Import> button in the <Steps> dialog box.

Locate and select the location and file name of the CAD file to be imported.