Administrator’s Guide(CP45FV) Eng.pdf - 第61页
Boar d Definition Chapter 6. Board Definition 6-1 The <PCB Edit> menu is composed of the eight s ubmenus: Board, Part, Feeder , Step, ANC Cfg, Cycle, Opti, Cancel. Used to edit data for the placement of com ponents…
Board Definition
Chapter 6. Board Definition
6-1
The <PCB Edit> menu is composed of the eight submenus: Board, Part, Feeder, Step,
ANC Cfg, Cycle, Opti, Cancel.
Used to edit data for the placement of components on a PCB (Printed Circuit Board ).
When a submenu of the <PCB Edit> menu is selected, the corresponding dialog box is
displayed. While the dialog box corresponding to the submenu is displayed, if the menu is
selected again, the corresponding dialog box is activated. Click on the button on the top
right to close the dialog box.
Figure 6-1. When the PCB Edit command is selected
Figure 6-2. Submenus of the PCB Edit command(Initial status)
Figure 6-3. Sub menus of the PCB Edit command(Activated status)
Use the <Board> command to edit the PCB (Printed Circuit Board) setup only. When this
button is selected, the following dialog box is displayed.
Samsung Component Placer CP45FV Series Administrator’s Guide
Figure 6-4. “PCB Edit : Board Definition” dialog box
<1. Customer Name> edit box
Enter the name of the customer who requested the PCB operation. Up to 64
characters can be entered.
<2. Board Name> edit box
Enter the PCB name. Up to 64 characters can be entered.
<3. Coordinate> combo box
Select the PCB coordinate system. Available coordinate systems are as follows.
Left-Up : Based on the front of machine, it is a coordinate system in which the
X axis increases to the left and the Y axis increases to the top.
Right-Up : Based on the front of machine, it is a coordinate system in which
the X axis increases to the left and the Y axis increases to the top.
Left-Down : Based on the front of machine, it is a coordinate system in which
the X axis increases to the left and the Y axis increases to the top.
Right-Down : Based on the front of machine, it is a coordinate system in which
the X axis increases to the left and the Y axis increases to the top.
<4. Initial Theta >
Set the initial theta for board data editing. At this time, the PCB should be already
loaded in the working area of the machine.
<Initial Theta - Teach> button
It is activated when there is fiducial mark data.
6-2