N7201A618E00_0309.pdf - 第13页
1 What if
NPM-W2 EJM7DE-CT-01T-00
S-12
1 What if
NPM-W2 EJM7DE-MB-01T-00
Cannot pickup
Feeder error
What if
Pickup motion error
Problem Cause
Check/Solution Reference
Intelligent Tape
Feeder
Operating
Instructions
6
1-1-1-1
Component data
error
DGS
Programming
Manual 6.5.3
Pickup condition
error
Check whether the pickup
pusher has been properly set.
Adjust if necessary.
Check the vacuum pressure
(appropriate pressure: -100 to
–87kPa). If it is not within the
value, Adjust the pressure.
Check the pickup position setting.
Adjust if necessary.
Check whether too much vacuum
leaks during component pickup.
Adjust if so.
Change to the appropriate pickup
speed.
Supply unit (feeder
or tray) setting
error or defect
Maintenance
4-1-1
Operating
procedure
6-2-4,6-2-6,6-2-8
DGS
Programming
Manual 6.5.3
DGS
Programming
Manual 6.5.3
[1.]
Maintenance
5-7
[2]
Contact us.
[3.]
Operating
procedure
6-1-10
[4,5]
Operating
procedure
2-4-2
6-1-10
Troubleshooting
1-1-1
1.Check feeding motion. Adjust if
there is an error.
2.Check for dust or chip
component stuck onto the tape
pusher cover. If so, clean the
cover.
3.Check the peeling motion.
Adjust if there is an error.
1.Check whether the component
thickness has been input
properly. Adjust if necessary.
2.Check the amount of feed of the
feeder and the tape type
(paper,embossed paper) Adjust
and replace if necessary.
1.Wipe off if the feeder attachment
part is contaminated, or remove
if components are jammed.
2.Replace the cutter blade if it is
not sharp enough.
3.Adjust if the tray pickup height Is
not set properly.
4.Fix the position if the tray is
installed incorrectly.
5.Check whether the tray is
properly set on the pallet. Fix it if
necessary
‐