N7201A618E00_0309.pdf - 第93页
NPM–W 2 EJM7DE-MB-02 -1T-00 Nozz le Recognition Err Nozzle Pos Diameter Err Solutions to errors Error Code Error Message Cause Inspection and Solution Both nozzle position and diameter were ju dged to be abnormal during …
NPM–W2 EJM7DE-MB-02-1T-00
Nozzle Diameter Error
Nozzle Position Error
Feeder Error Rate Over
Error
Message
Troubleshooting
2-1-3
Single stop error 12
Error Code
Error Message
Cause Inspection and Solution
Machine stopped since the
tape feeder error rate
((Pickup error count +
Recognition error count) /
Pickup count) of the feeder
concerned has exceeded the
specified limit.
(Single stop error occurred.)
Take any of the following measures:
1) Make sure the judgment criteria
value is correct on the bad
judgment value screen of the
machine parameter.
2) Choose [Prod. info.] - [Pickup
info.] and identify the cause
(pickup error or recognition error).
Then perform appropriate
maintenance and clear the setting
of the bad nozzle.
40371
Nozzle position was judged
to be abnormal during nozzle
position recognition.
(Single stop error occurred.)
Check the nozzles are free of bend
or other defects.
40372
Nozzle diameter was judged
to be abnormal during nozzle
position recognition.
(Single stop error occurred.)
Make sure that correct nozzles are
attached.
40373
2-1-3-22
NPM–W2 EJM7DE-MB-02-1T-00
Nozzle Recognition Err
Nozzle Pos Diameter Err
Solutions to errors
Error Code
Error Message
Cause Inspection and Solution
Both nozzle position and
diameter were judged to be
abnormal during nozzle
position recognition.
(Single stop error occurred.)
Take any of the following measures:
1) Make sure that correct nozzles
are attached.
2)Check the nozzles are free of
bend or other defects.
40374
Nozzle recognition failed
during nozzle position
recognition.
(Single stop error occurred.)
Take any of the following measures:
1) Make sure that correct nozzles
are attached.
2) Check the nozzles are free of
bend or other defects.
3) Make sure the light of the parts
recognition camera is lit during
nozzle recognition. If not lit,
contact PFSC.
40375
2-1-3-23
NPM–W2 EJM7DE-MB-02-1T-00
Nzl Chg Mark Recog Err
Nzl Changer Close Err
Nozzle Changer Open Err
Error
Message
Troubleshooting
2-1-3
Single stop error 13
Error Code
Error Message
Cause Inspection and Solution
Nozzle changer failed to
open within the prescribed
time.
(Single stop error occurred.)
Choose [Machine] - [Adjust] - [All] -
[Output confirm] and open/close the
nozzle changer. Check for proper
movement. If stopped or caught on
the way, perform cleaning.
40376
Nozzle changer failed to
close within the prescribed
time.
(Single stop error occurred.)
Choose [Machine] - [Adjust] - [All] -
[Output confirm] and open/close the
nozzle changer. Check for proper
movement. If stopped or caught on
the way, perform cleaning.
40377
Failed to recognize the mark
of nozzle changer.
(Single stop error occurred.)
Make sure the mark of the nozzle
changer is free of dirt or dust.Make
sure the light of the head camera is
lit during recognition of nozzle
changer mark. If not lit, contact
PFSC.
40378
2-1-3-24