N7201A618E00_0309.pdf - 第144页
NPM–W 2 EJM7DE-MB-02 -1T-00 Parts Re cognition Error Error Message Troubleshooting 2-1-3 Single stop er r or 38 Error Code Error Message Cause Inspection and Solution The det ected electrode pattern differs from the regi…
NPM–W2 EJM7DE-MB-02-1T-00
Parts Recognition Error
Solutions to errors
Error Code
Error Message
Cause Inspection and Solution
The electrode array of an
electrode (lead or ball type)
array component was not
properly detected because
either the electrode pitch or
quantity was determined to
be incorrect.The detected
electrode pitch does not
match input data.The input
quantity of electrodes were
not detected.
(Recognition error -
Electrode pitch or count)
Check the registered electrode
arrangement data (lead group, ball
group).Make sure the registered
shape data agrees with the actual
component image.Make sure the
registered arrays and pitches agree
with the actual component status.
43037
2-1-3-73
NPM–W2 EJM7DE-MB-02-1T-00
Parts Recognition Error
Error
Message
Troubleshooting
2-1-3
Single stop error 38
Error Code
Error Message
Cause Inspection and Solution
The detected electrode
pattern differs from the
registered pattern.The
required electrodes were not
detected.A shape similar to
an electrode was detected
near to a registered
electrode.This error also
occurs if an electrode is
detected in an unnecessary
location in recognition option:
unnecessary lead judgment.
(Recognition error -
Electrode array pattern)
Take any of the following measures:
1) Check the condition of the
component's electrodes.In case of
the error of Ans38 (30-39), an
error is detected when performing
detailed check.At this time, check
if the electrode arrangement data
is correct.On a particular note, with
Ans38 (35~39), processing for the
recognition option: unnecessary
lead judgment resulted that an
unnecessary electrode shape was
detected in an unregistered
position.
2) Check the image status
(brightness) of component's
electrodes.In case of error of
Ans38 (20~29), an error is
detected in the general positioning
processing of electrode
arrangement.At this time, check for
proper electrode size (width,
diameter), or check for proper
electrode image.If the electrodes
are unclear on the image, adjust
the lamp value.
43038
2-1-3-74
NPM–W2 EJM7DE-MB-02-1T-00
Parts Recognition Error
Parts Recognition Error
Solutions to errors
Error Code
Error Message
Cause Inspection and Solution
Detected angle of
component's electrode is
invalid.
- The difference between
angle of electrode and angle
of component itself is too
much.
- Abnormal error in angle of
detected electrode column
with arrangement electrode
component
(Recognition error -
Electrode angle)
Take any of the following measures:
1) Check the component pickup
condition.Make sure the picked up
component is not slanted or
improperly rotated.
2) Check the condition of the
electrodes.Check the component
for broken or bent electrodes.
43039
Improper component's
electrode position or
component outer shape
position determined by
detected electrode position.
- The array corner mark of a
lead array or ball array
component obtained from
the detected outer electrode
was outside the recognition
window.The component
center position of a
unidirectional lead array
component obtained from
the lead array was outside
the recognition window.
- Detected electrode position
is out of recognition window.
(Recognition error -
Electrode position)
Take any of the following measures:
1) Check the component pickup
condition.Check the component for
proper pickup angle.
2) Check the data related to
component size.If the component
is out of the screen on the
recognition error image, check the
component outer shape size.For 1-
way lead array components, check
the component outer shape size or
registered position of the lead
column.
43040
2-1-3-75