N7201A618E00_0309.pdf - 第166页

NPM–W 2 EJM7DE-MB-02 -1T-00 SupportPin exchange error SupportPin mount err or SupportPin pick up err or SupportPin exist error SupportPin unexist er ror Error Message Troubleshooting 2-1-3 Single stop er r or 49 Error Co…

NPM–W2 EJM7DE-MB-02-1T-00

SupportPin descend error

SupportPin rise error

PCB stop pos sensor error

Transfer motor is

abnormal

Solutions to errors

Error Code

Error Message

Cause Inspection and Solution

Transfer motor driver error

detected during PCB transfer.

(Transfer motor error

occurred.)

Take any of the following measures:

1) Check the transfer motor.

2) Check the condition of the safety

cover and emergency stop switch.

3) Check the situation of the error

occurred and contact PFSC.

44014

Overrun sensor turned ON

prior to PCB stop position

sensor when loading PCBs.

(Error in PCB stop position

sensor error.)

Take any of the following measures:

1) Check the PCB on the conveyor

and condition of the PCB sensor.

2) Check the situation of the error

occurred and contact PFSC.

44015

Failed to raise PCB support.

(Single stop error occurred.)

Check the condition of the upper

limit sensor on the PCB support.

44016

Failed to lower PCB support.

(Single stop error occurred.)

Check the condition of the lower limit

sensor on the PCB support.

44017

2-1-3-95

NPM–W2 EJM7DE-MB-02-1T-00

SupportPin exchange

error

SupportPin mount error

SupportPin pick up error

SupportPin exist error

SupportPin unexist error

Error

Message

Troubleshooting

2-1-3

Single stop error 49

Error Code

Error Message

Cause Inspection and Solution

Failed to recognize support

pins.

(Single stop error occurred.)

Please return all support pin to the

home position in arrange

screen.Confirm if the dirt is adhered

to PCB support block surface and

support pin underside, please clean.

44018

There were support pins at

unnecessary positions.

(Single stop error occurred.)

Return all support pins to home

positions via the Arrange screen.

44019

Failed to pick up support pins.

(Single stop error occurred.)

Clean the nozzle and filter. Return

all support pins to home positions

via the Arrange screen.

44020

Failed to mount support pins.

(Single stop error occurred.)

Clean the nozzle and filter. Return

all support pins to home positions

via the Arrange screen.

44021

Failed to replace support

pins.

(Single stop error occurred.)

Make sure the support pins can be

replaced via the Arrange screen.

44022

2-1-3-96

NPM–W2 EJM7DE-MB-02-1T-00

Upper System Interlock

Error

PinNzlChanger recog err

SupportPin bcd

mismatched

SupportPin nzl not exist

Solutions to errors

Error Code

Error Message

Cause Inspection and Solution

All nozzles for support pin

replacement are set as bad

nozzle.

(Single stop error occurred.)

Clear the setting of bad nozzle.

44023

Invalid 2D barcode of the

nozzles for support pin

replacement.

(Single stop error occurred.)

Make sure the nozzle in the nozzle

changer for support pin replacement

is set correctly.

44024

Any of the following causes

is likely:

1) Nozzle changer mark for

support pin replacement is

out of camera's recognition

view.

2) Recognition error

occurred due to dirt on

mark^ etc.

(Single stop error occurred.)

Check the mark condition of the

nozzle changer for support pin

replacement.

44025

The interlock request is

arriving from upper system.

(Single stop error occurred.)

Please confirm the state of upper

system.

44026

2-1-3-97