N7201A618E00_0309.pdf - 第187页
NPM–W 2 EJM7DE-MB-02 -1T-00 Tape cover detection 1 (Rear) Solutions to errors Error Code Error Message Cause Inspection and Solution Tape cover sensor 1 is blocked. (Interlock occurred.) Take any of the following measure…
NPM–W2 EJM7DE-MB-02-1T-00
Tape cover detection1
(Front)
Error
Message
Troubleshooting
2-1-4
Emergency stop errors
9
Error Code
Error Message
Cause Inspection and Solution
Tape cover sensor 1 is
blocked.
(Interlock occurred.)
Take any of the following measures:
1) Close the front cover of the tape
feeder.
2) Set the toggle lever of the tape
feeder properly.
3) Make sure that detection area of
the tape cover sensor is not
blocked by the top tape or big
component.
4) Choose [Machine] - [Adjust] - [All]
- [Input confirm] and check that the
feeder opening sensor 1 of the
table is OFF when the light from
the emitter is blocked and ON
when the light from the emitter
reaches the detector. At this time,
make also sure that the green LED
is lit when the light from the emitter
is blocked and the green and red
LEDs are lit when the light from
the emitter reaches the detector.
1334
2-1-4-17
NPM–W2 EJM7DE-MB-02-1T-00
Tape cover detection1
(Rear)
Solutions to errors
Error Code
Error Message
Cause Inspection and Solution
Tape cover sensor 1 is
blocked.
(Interlock occurred.)
Take any of the following measures:
1) Close the front cover of the tape
feeder.
2) Set the toggle lever of the tape
feeder properly.
3) Make sure that detection area of
the tape cover sensor is not
blocked by the top tape or big
component.
4) Choose [Machine] - [Adjust] - [All]
- [Input confirm] and check that the
feeder opening sensor 1 of the
table is OFF when the light from
the emitter is blocked and ON
when the light from the emitter
reaches the detector. At this time,
make also sure that the green LED
is lit when the light from the emitter
is blocked and the green and red
LEDs are lit when the light from
the emitter reaches the detector.
1335
2-1-4-18
NPM–W2 EJM7DE-MB-02-1T-00
No Feeder cover
(Rear)
No Feeder cover
(Front)
Error
Message
Troubleshooting
2-1-4
Emergency stop errors
10
Error Code
Error Message
Cause Inspection and Solution
Feeder cover not attached.
(Interlock occurred.)
Take measures in the following
order.
1) Attach the feeder cover.
2) If the error persists even after the
feeder cover is attached, the
connection with the feeder cover
may not be detected.Choose
[Machine] - [Adjust] - [All] - [Input
confirm] and check the connection
of feeder cover.
1336
Feeder cover not attached.
(Interlock occurred.)
Take measures in the following
order.
1) Attach the feeder cover.
2) If the error persists even after the
feeder cover is attached, the
connection with the feeder cover
may not be detected. Choose
[Machine] - [Adjust] - [All] - [Input
confirm] and check the connection
of the feeder cover.
1337
2-1-4-19